Related Manuals for Titan TTI836LWM
Summary of Contents for Titan TTI836LWM
- Page 1 Lawnmower 18V 34cm TTI836LWM WARNING: Read the instructions before using the product!
-
Page 2: Table Of Contents
Let’s get started... These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference. started... Getting Safety information Your product Before you start detail... more Product functions Operation Care and maintenance Troubleshooting Recycling and disposal Guarantee Technical specifications... - Page 3 TTI836LWM by TITAN Safety information Safety warnings 1. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for their safety.
- Page 4 Safety information TTI836LWM by TITAN Safety warnings 3. Never mow while people, especially children, or pets are nearby. 4. Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property.
- Page 5 TTI836LWM by TITAN Safety information 9. Stop the cutting blade(s) if the product has to be tilted for transportation when crossing surfaces other than grass, and when transporting the product to and from the area to be mowed. 10. Never operate the product with defective guards or shields, or without safety devices, for example deflectors and/or grass catchers, in place.
- Page 6 Safety information TTI836LWM by TITAN Safety warnings 18. If the product starts to vibrate abnormally (check immediately) - inspect for damage, - replace or repair any damaged parts, - check for and tighten any loose parts. Maintenance and storage 1. Disconnect the product from the power supply (i.e.
-
Page 7: Safety Information
TTI836LWM by TITAN Safety information 11. Have the product repaired only by an authorised service centre or similar qualified specialist. 12. When not in use, store the product out of the reach of children. Safety warnings for battery pack 1. Recharge the battery pack only with the charger specified by the manufacturer. - Page 8 Safety information TTI836LWM by TITAN Safety warnings serious personal injury, never use any cordless product in the presence of an open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately. 8. Follow all charging instructions and do not charge the battery pack outside the temperature range specified in the instructions.
- Page 9 TTI836LWM by TITAN Safety information 16. When disposing of battery pack, keep the battery pack of different electrochemical systems separate from each other. Vibration and noise reduction To reduce the impact of noise and vibration emission, limit the time of operation, use low-vibration and low-noise operating modes as well as wear personal protective equipment.
- Page 10 Safety information TTI836LWM by TITAN Safety warnings 2. Switch the product off and remove the battery pack if there are malfunctions. Have the product checked by a qualified professional and repaired, if necessary, before you operate it again. Residual risks...
- Page 11 TTI836LWM by TITAN Safety information Symbols On the product, the rating label and within these instructions you will find among others the following symbols and abbreviations. Familiarise yourself with them to reduce hazards like personal injuries and damage to property.
- Page 12 Safety information TTI836LWM by TITAN Symbols Inspect the area where the product is to be used and remove all objects which can be thrown by the product. If objects are hidden while operating stop the motor and remove the object.
- Page 13 TTI836LWM by TITAN Safety information Do note expose battery packs to heat in excess of 40 ºC. Do not charge or store the battery pack in temperatures below 5 °C (41 °F) and above 40 °C (104°F). The product complies with the applicable European directives and an evaluation method of conformity for these directives was done.
-
Page 14: Your Product
Your product TTI836LWM by TITAN Your product 11 10... - Page 15 TTI836LWM by TITAN Your product / Before you start 1. Grip handle 8. Transport handle c. Slot* 2. Safety switch button a. indicator* 16. Deflector guard 3. Start lever (x2) 9. Rear wheel (x2) 17. Wire clip (x2) 4. Upper handle bar 10.
-
Page 16: Before You Start
Before you start TTI836LWM by TITAN You will need (items not supplied) (items supplied) Suitable personal protective equipment Grass catcher (7) Suitable wrench Cutting blade (12d) Battery pack (20) Charger (21) and its manual NOTE: The accessories required depend on the intended application. - Page 17 TTI836LWM by TITAN Before you start 1. Unfold and loosen the clamp levers (5) anti-clockwise on the lower handle bars (6), but do not remove them (Fig.1, step 1). 2. Grasp the lower handle bars (6) and unfold them from storage position to work position (Fig.
- Page 18 Before you start TTI836LWM by TITAN Assembly Fig. 3 8. Secure the inter-connection cord (18) with two wire clips (17) (Fig. 3). Pull the inter-connection cord (18) to avoid contact with the rear wheel (9) if necessary. Fig. 4 WARNING! Make sure the clamp levers (5) are properly tightened before using the product.
- Page 19 TTI836LWM by TITAN Before you start WARNING! Do not attempt to use the product without the grass catcher attached – danger of flying objects! The motor must be switched off and the blade must have stopped rotating before you remove the grass catcher. The grass catcher must be fully assembled with the top part, bottom part and collection tongue all in position before first use.
- Page 20 Before you start TTI836LWM by TITAN Battery pack Attaching the battery pack 1. Remove the safety key (10) and keep it avoid loss (Fig. 8, step 1). 2. Hold the groove (15a) and open the battery cover (15) (Fig. 8, step 2).
- Page 21 TTI836LWM by TITAN Before you start Battery pack Charging the battery pack The battery pack (20) for this product has been shipped in a low charge condition. Charge it fully before first use. Refer to the charger instruction manual (TTB805CHR) for the details.
-
Page 22: In More Detail
TTI836LWM by TITAN more detail... Product functions Operation Care and maintenance Troubleshooting Recycling and disposal Guarantee Technical specifications Declaration of conformity... - Page 23 TTI836LWM by TITAN Product functions Intended use This cordless lawn mower TTI836LWM is designated with rated voltage of 18 V . It is designed only to be used with the battery pack which is listed in the chapter of “Technical specifications”.
- Page 24 Product functions TTI836LWM by TITAN Handle height adjustment 3. Secure the handle assembly by folding up the clamp lever (5) towards the transport handle (8). If clamp lever (5) cannot be folded, loosen it and fold again. If it is too loose, tighten it by turning the clamp lever (5) clockwise (Fig.
- Page 25 TTI836LWM by TITAN Product functions Fig 13 WARNING! Make sure the clamp levers (5) are properly tightened before using the product. Cutting height adjustment WARNING! Switch the product off and wait that the cutting blade had come to a complete stop before adjusting the cutting height! Remove the safety key (10) before adjusting the cutting height! Adjust the cutting height according to the needs of your lawn.
-
Page 26: Operation
Product functions TTI836LWM by TITAN Grass catcher WARNING! Do not attempt to use the product without the grass catcher attached when collecting grass – danger of flying objects! Switch the motor off and wait that the blade had come to a complete stop before removing the grass catcher! Attach the grass catcher (7). - Page 27 TTI836LWM by TITAN Product functions / Operation 2. Lift the deflector guard (16) and lift the grass catcher (7) off the hooks. 3. Remove the grass clippings from the rear discharge chute (19) into the grass catcher (7). Use a proper tool such as a brush.
- Page 28 Operation TTI836LWM by TITAN Grass catcher Starting / stopping NOTE: The product can only be started by pressing the safety switch button (2) followed by squeezing the start levers (3). Reverse operation cannot start the product. 1. Install the battery pack (20) into the battery compartment.
- Page 29 TTI836LWM by TITAN Operation / Care and maintenance 5. Mow in slight overlapping rows. The most effective pattern for mowing lawns is straight lines along one of the sides. This will keep the rows even and ensures that all the lawn is cut without missing any spots (Fig.
-
Page 30: Care And Maintenance
Care and maintenance TTI836LWM by TITAN General Cleaning 1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach. 2. Remove stubborn dust with high pressure air (max. 3 bar). NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents or disinfectants to clean this product as they might be harmful to its surfaces. - Page 31 TTI836LWM by TITAN Care and maintenance 5. Replace the cutting blade (12d) with a new one of the same type. Check the status of flange (12c), the bushing (12b) onto the spindle (12a) firstly, then attach the cutting blade (12d) and hex nut (12e) properly. Tighten the hex nut (12e) clockwise with 20 Nm min, 25 Nm max.
-
Page 32: Troubleshooting
Care and maintenance TTI836LWM by TITAN Storage 1. Switch the product off, disconnect the safety key (10) and remove the battery pack (20) before storage. 2. Clean the product as described above. 3. Fold the handle assembly to the storage position. - Page 33 TTI836LWM by TITAN Troubleshooting Problem Possible cause Solution 1. Product does 1.1. Battery pack is not 1.1. Attach properly not start properly attached 1.2. Battery pack is 1.2. Remove and charge discharged battery pack 1.3. Battery pack is damaged 1.3. Check by a specialist electrician 1.4.
-
Page 34: Recycling And Disposal
Recycling and disposal TTI836LWM by TITAN Recycling and disposal Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice. For further information visit www.recycle-more.co.uk. -
Page 35: Guarantee
TTI836LWM by TITAN Guarantee Guarantee We take special care to select high quality materials and use manufacturing techniques that allow us to create products incorporating design and durability. This product has a manufacturer’s guarantee of 2 years against manufacturing defects, from the date of purchase (if bought in store) or date of delivery (if bought online), at no additional cost for normal (non-professional or commercial) household use. - Page 36 Guarantee TTI836LWM by TITAN Guarantee Distributor: B&Q plc Chandlers Ford, Hants, SO53 3LE, United Kingdom www.diy.com Screwfix Direct Limited Trade House, Mead Avenue, Yeovil, BA22 8RT, United Kingdom www.screwfix.com...
-
Page 37: Technical Specifications
TTI836LWM by TITAN Technical specifications Technical specifications General > Rated voltage : 18 V > Rated no load speed n : 3000 min > Max. cutting width : 34 cm > Cutting height range : 20-70 mm, 6 levels > Grass catcher volume : 35 l >... - Page 38 Proper measures include among others regular maintenance and care of the product and accessories, keeping hands warm, periodical breaks and proper planning of work processes. Rating label explanation Lawn mower: TTI836LWM = Model number TTI=TITAN brand 836=Series number LWM=lawn mower...
-
Page 39: Declaration Of Conformity
TTI836LWM by TITAN Declaration of conformity Declaration of conformity...
Need help?
Do you have a question about the TTI836LWM and is the answer not in the manual?
Questions and answers