Configuring Navigation Update Rate; Configuring Power Modes; Configuring Backup Modes - u-blox EVK-F10N User Manual

Configuration layer
RAM
BBR
FLASH
Table 7: UBX binary string to override GPS L5 signal health status with GPS L1 health status
Configuration layer
RAM
BBR
FLASH
Table 8: UBX binary strings to revert the GPS L5 signal health status monitoring to default
9.4 Configuring navigation update rate
The CFG-RATE-MEAS configuration key that is shown in
the navigation update rate. The navigation update rate value is defined in ms, where 100 ms
corresponds to 10 Hz. The default update rate is 1000 ms which corresponds to 1 Hz. The default
1 Hz update rate is a good tradeoff between position accuracy and power consumption. Certain
applications require faster update rates for high performance but this will increase the receiver
power consumption.
When high navigation update rates are used, increase the communication baud rate and reduce
the number of enabled messages. The maximum baud rate of 921600 or 460800 is sufficient
for most use cases.
Figure 19: EVK-F10N receiver navigation update rate configuration
9.5 Configuring power modes
EVK-F10N supports continuous power mode only. This is the full power mode and the default mode
of the receiver.
9.5.1 Configuring backup modes
EVK-F10N supports two backup modes: hardware backup mode and software standby mode.
UBXDOC-963802114-12252 - R03
C1-Public
Configuration string
B5 62 06 8A 09 00 01 01 00 00 01 00 32 10 01 DF F6
B5 62 06 8A 09 00 01 02 00 00 01 00 32 10 01 E0 FE
B5 62 06 8A 09 00 01 04 00 00 01 00 32 10 01 E2 0E
Configuration string
B5 62 06 8A 09 00 01 01 00 00 01 00 32 10 00 DE F5
B5 62 06 8A 09 00 01 02 00 00 01 00 32 10 00 DF FD
B5 62 06 8A 09 00 01 04 00 00 01 00 32 10 00 E1 0D
9 Configuring the device
EVK-F10N - User guide
Figure 19 can be used to configure
Page 25 of 33