Dlm Box Configuration - Verve Connect v.go R7A Installation Manual

Step 4 – Secure DLM Box to wall:
Drill and secure the DLM Box to the wall using the four corner holes in the case
ensuring that there is no cable strain on any of the connections.

DLM Box configuration

The purpose of this step is to let the System know the maximum current that the
property can withdraw so that the charger does not exceed this.
If the Maximum current that the property can withdraw from the grid (i.e. the
property's fuse) is 60A or 63A then it is recommended that you do not change the
settings. By default, the DLM Box is set to 60A.
To configure the DLM Box, you need to connect to it in the same way as connecting to
the V-Go Charger.
You will require any WiFi enabled device (phone, tablet or laptop) and a web browser.
Please refer to Internet configuration section of this manual for more detailed
instructions on how to access the Web User Interface.
SSID of the DLM Box:
Password:
Address to search once connected:
Step 5 – Configure the DLM box:
a) Once connected to the SSID of the DLM Box, type 192.168.4.1 into the search
bar.
b) Once the page is loaded, click on the DLM page in the bottom right-hand
corner to access the DLM configuration.
c) Define the maximum current that the property can withdraw (i.e. 80A/100A
depending on the property's inlet fuse) and click confirm.
The DLM Box configuration is finished and complete.
"dlb_softap"
192.168.4.1
43
N/A