Table of Contents
Advertisement
Specifications
■ Front speaker. Center speaker. Rear speaker
Front speaker
Center speaker
Rear speaker
System
2 way
(Magnetically shielded)
2 way
(Magnetically shielded)
1 way
Enclosure
Acoustic Air Suspension
Acoustic Air Suspension
Acoustic Air Suspension
Loudspeaker
100 mm(4") Cone type
(Full Range type)
Woofer:
100 mm(4") Cone type
100 mm(4") Cone type
—
Tweeter:
50 mm(2") Cone type
50 mm(2") Cone type
—
Nominal Impedance
8
o
8Q
8 O
Peak Input Power
—
80 W
80 W
Maximum Input Power
80 W
40 W
40 W
Sensitivity
88 dB / W at 1 m
88 dB / W at 1 m
85 dB / W at 1 m
Frequency Response
100 Hz-20,000 Hz
100 Hz~20,000 Hz
100 Hz~20,000 Hz
Crossover Frequency
3,000 Hz
3,000 Hz
—
Dimensions
Width:
129 mm(5-1/16")
129 mm(5-1/16")
129 mm(5-1/16")
Height:
198 mm(7-13/16")
198 mm(7-13/16")
198 mm(7-13/16")
Depth:
120 mm(4-3/4")
120 mm(4-3/4")
120 mm(4-3/4")
Net Weight
1.2 kg (2.6 lb) /piece
1.0 kg (2.2 lb)
0.8 kg (1.8 lb) /piece
■ Subwoofer
n
System
Subwoofer system with built-in amplifier
Output Power
50 Watts RMS, at 40 from 40 Hz to 160 Hz
with no more than 0.09% total harmonic distortion
Input Sensitivity/Impedance
RCA-type pin-plug jack (LINE IN):
100 mV/43 kC2, 200 mV/43 ka (MONO)
Push-type terminals:
1.8V/1.2 kQ
Turn Over Frequency
80 Hz ~ 160 Hz
Phase Switching
NORMAL, REVERSE
Enclosure
Bass-Reflex
Loudspeaker
200 mm (8") Cone type
Nominal Impedance
40
Frequency Response
40 Hz ~ 250 Hz
Power Consumption
now
Supply Voltage
AC120V, 60 Hz
Dimensions
Width:
286 mm (11-1/4")
Height:
368 mm (14-1/2")
Depth:
356 mm (14")
Net Weight
11.2 kg (24.7 lb)
Enclosure Finish
High density particle board laminated with simulated wood grain vinyl.
NOTE: THE GRILLES ON ALL THE SPEAKERS CANNOT BE REMOVED.
Notes: -------
1. Kenwood follows a policy of continuous advancements in development. For this reason, specifications may be changed
withou notice.
2. Full performance may not be exhibited in extremely cold locations (below 0 deg. C).
Advertisement
Table of Contents
