Yamaha HTR-6260 Owner's Manual page 66

Troubleshooting
Problem
No picture.
The sound suddenly
goes off.
Sound is heard from
the speaker on one
side only.
Only the center
speaker outputs
substantial sound.
No sound is output
from a specific
speaker.
No sound is heard
from the presence
speakers.
62
En
Cause
An appropriate video input is not selected
on the monitor.
The composite output terminals are used
to output a component video signal, or the
COMPONENT VIDEO jacks are used to
output a composite video signal.
This unit outputs the video signals are not
supported on the video monitor connected
to the HDMI OUT jack.
Non-standard video signals are input.
The protection circuitry has been activated
because of a short circuit, etc.
The sleep timer has turned off this unit.
The playback component or speakers are
not connected properly.
The speaker level settings are incorrect.
When a monaural source sound field
program is applied, sound of all channels
are output from the center speaker for
some surround decoders.
Output from that speaker is disabled.
The volume of that speaker is set to
minimum in Speaker Setup in the Setup
menu.
This unit or speaker is malfunction.
This unit is in the "STRAIGHT" mode.
Sound may not be output from certain
channels depending on the input source or
sound field program.
Remedy
Select an appropriate video input on the monitor.
If your monitor does not support the HDMI
connection, connect it to the COMPONENT OUT
jacks or the composite output terminals and select an
appropriate video input on the monitor.
Displays the advanced setup menu and select
"VIDEO" in "INIT" to reset the video parameters.
Displays the advanced setup menu and set
"MON.CHK" to "YES."
Connect the monitor to this unit via the
COMPONENT OUT jacks or the composite output
terminals.
Check that the speaker impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust "B)Level" settings.
Try another sound field program.
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker.
Select another sound field program.
3) "None" may have been selected for that speaker on
this unit. Display Speaker Setup in the Setup menu
and enables output of that speaker.
Display Speaker Setup in the Setup menu and adjust
the volume (2 Manual Setup → B)Level).
Check the Speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
Press MSTRAIGHT or the kSTRAIGHT on the
remote control to turn off the "STRAIGHT" mode.
Try another sound field program.
See
page
—
14
60
60
14
60
—
—
11
53
25
6, 22, 25,
52
53
6, 10
28
25