Husqvarna 330iKE Operator's Manual page 14

safety chapter and the assembly
instructions.
To install the shaft into the gearbox
1. Loosen the clamp screw (A) and remove
the set screw (B).
A
B
2. Align the arrow on the shaft with the set
screw hole in the gearbox.
3. Push the shaft until the line mark (C)
touches the gearbox.
4. Align the set screw holes in the shaft and
the gearbox.
5. Replace and tighten the set screw.
6. Tighten the clamp screw.
To assemble the loop handle
1. Attach the loop handle onto the shaft
between the arrows.
2. Move the spacer into the slot of the loop
handle.
3. Install the screw and the knob. Do not
tighten too much.
4. Adjust the loop handle to an applicable
position.
5. Tighten the knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
14
2. Align the tab of the cutting attachment (A)
with the notch of the coupling (B).
C
3. Carefully push the shaft into the coupling
until you hear a click.
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen
the coupling.
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the
motor is attached to.
B
A
2114 - 004 - 03.11.2023