Stratco SS-10434 Assembly Manual

Each shelf can hold a maximum load of 45kg. Please carefully read and follow these
instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
WARNING: SERIOUS INJURY CAN BE CAUSED BY TOPPLING FURNITURE. To help
prevent tip-over, we recommend you anchor this product to a wall or other suitable surface. Check anchors regularly.
Step 1
CHECK PARTS LIST
TOOLS REQUIRED:
• Phillips Head
Screwdriver
There may be minor variations in the
appearance of some parts from
illustrations due to continued
product improvements.

Step 2

C
M
C
Y
C
M
CM
M
Y
MY
Y
Stand the back and right
CY
CM
CM hand side upright.
CMY
MY
MY
K
CY

Step 5

CY
CMY
CMY
K
K
Insert the cupboard door section
from the inside of the unit.
1
OCTOBER 2023
2 DOOR METAL
STORAGE UNIT
1 x Front Panel
(Doors & Frame)
2 x Plastic Covers 10 x Screws
Screw in top and middle screws
Fit bottom shelf making sure side slots line up
and that the front of the shelf sits on the lip.
TIP
• Get your components ready ahead of the next procedure.
• Use care when using an electric screwdriver not to strip the thread on the screwholes.
1 x Rear Wall 2 x Side Panels
(install this way up & face
detail towards inside of cabinet)
4 x Shelf Supports

Step 3

to secure Back and RH Side.

Step 6

SS-10434
Top
1 x Middle Shelf
Bottom Shelf
2 x Keys

Step 4

Repeat for LH Side.

Step 7

Lay unit on it's back and fix
bottom screw in lower shelf.