Yamaha PSR-S710 Owner's Manual page 78

4
Press the [E] (RECORDER) button to call up the Recording
display (USB AUDIO RECORDER display).
Check the information of the USB flash memory as a recording
destination
On the display of step 4, press the [E] (PROPERTY) button to check the
number of the USB flash memory device, memory size of the device, avail-
able recording space on the device, and available time for recording.
Press the [F] (OK)/[EXIT] button to close the PROPERTY display.
7
5
Start recording by pressing the [J] (REC) button, then start your
performance.
When recording begins, the elapsed recording time is shown on the right side of
the Recording display.
6
Stop recording by pressing the [J] (STOP) button.
The file name is automatically named, and a message indicating the file name is
displayed.
78
PSR-S910/S710 Owner's Manual
NOTE
The USB storage device of "USB1" is
selected as the recording destination
when multiple USB storage devices
are connected. The destination is
skipped when "USB1" is a floppy disk
drive.
CAUTION
Never attempt to disconnect the
USB flash memory or turn the
power off during playback.
Doing so may corrupt the USB
flash memory data or the
recording data.
NOTE
Even if you make a mistake in your
performance, you cannot overwrite an
existing file. Delete the recorded file
on the File Selection display, then
record your performance again.
NOTE
The recording operation continues,
even if you close the Recording dis-
play by pushing the [EXIT] button.
Press the [E] (RECORDER) button to
call up the Recording display again,
then stop the recording by pressing
the [J] (STOP) button.