Changing The Transmission Drive Belt - Cub Cadet LT1022 Operator's Manual

Electric PTO Clutch
Left Hand Pulley
Deck Idler Pulley
NOTE:
Left hand belt cover not shown for clarity.
Electric PTO Clutch
(beneath belt guard)
NOTE:
Models 1022 & 1024 are equipped with a different size deck. However, the belt routing of each is the same .

Changing The Transmission Drive Belt

NOTE:
An air/impact wrench is needed to remove the
electric PTO and properly replace the drive belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
The V-belts found on your tractor are
IMPORTANT:
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
Center Pulley
Right Hand Pulley
Deck Idler Pulleys
PTO Idler Bracket
(mounted on tractor)
Self-Tapping Screws
Figure 18
Right Hand Pulley
(beneath belt guard)
Self-Tapping Screws
Figure 19
use factory approved belts.
To change or replace the drive belt on your tractor,
proceed as follows:
• Remove the cutting deck as instructed earlier in this
section.
• After disconnecting the battery cables, remove the
battery and battery tray from beneath the seat.
When removing the battery, disconnect
IMPORTANT:
the NEGATIVE (Black) wire from it's terminal first,
followed by the POSITIVE (Red) wire. Re-install in
reverse order.
22
Model 1018
Deck belt (Bottom)
PTO belt (Top)
Right Hand Pulley
(beneath belt guard)
Models 1022 & 1024
Deck / PTO Belt