Woods 59745 - Programmable In Wall Timer Manual

Installation

1. Turn the power OFF at the circuit breaker or remove the fuse.
2. While holding the timer in your hand and using a toothpick, poke the hole in the arrow plate to gently remove the arrow plate.
3. Lift off the timer segment dial.
4. Move the manual switch on the timer plate to the OFF position.
5. Unscrew the 2 small screws to release the timer faceplate.
6. To confirm the timer is off, the manual switch control lever (located in the bottom right corner of the timer module) should be positioned to the far left.
7. Ensure neutral (white) wire is present in the junction box. If this wire is not present, additional wiring will be necessary before installation can be completed.
8. Strip 3/8" insulation from each wire, which is required for installation.
9. Connect the white wire from the timer to the white wire(s) in the junction box. Secure the connection with a wire connector.
10. Connect the black wire from the timer to the black (HOT) wire (previously connected to the switch) and connect the red wire from the TIMER to the second black wire (previously connected to the switch).
11. Carefully tuck all wires to provide room for the timer in the junction box.
12. Secure the timer module to the junction box with the 2 long screws (included).
13. Attach the decorator wall plate to the timer module (not included).
14. Attach the timer faceplate to the timer module with the 2 short screws (included).
15. Place the timer segment dial onto the timer module and rotate the dial clockwise for several rotations to ensure it rotates smoothly. Note: the segment dial will "click" as it rotates when properly secured.
16. Place the arrow plate with TIME NOW pointing to the lower left corner and push to insert.
17. Reconnect the electrical power.

Instructions

1. To set the current time: rotate the dial clockwise until the time lines up with the TIME NOW arrow. Note, PM hours are shaded.
2. To program the timer: begin with all segment pins pulled up. Push the segment pins down for the periods of time you want the timer to be ON. Each segment pin represents 30 minutes: 2 segment pins = 1 hour.
3. To override the timer: slide the switch on bottom of the timer to the ON position.
   "ON" - the connected device is switched on permanently.
   "OFF" - the connected device is switched off permanently.
   "TIMER" - the connected device follows your programmed timer settings.

Note: If the timer is not functional, interchange the two black wires previously connect to switch (see#10 above).

www.colemancable.com