Troubleshooting; Malfunction Table - Siemens HB73AB 41S Series Instruction Manual

Table of Contents

Advertisement

Do NOT unscrew the left and right-hand screws from the
7.
sheet metal part (fig. E).
(
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Slide in the middle panel (fig. B).
2.
$

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
0
Power cut
and three
zeros light up in
the display.
The oven does
There is dust on
not heat up.
the contacts.
16
%
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
4.
Hook the seal in to the bottom of the panel again (fig. D).
&
Insert the uppermost panel at an angle to the back into the
5.
brackets. Take care not to push the seal to the back (fig. E).
6.
Insert the two small seals on the left and right of the panel
again (fig. F).
(
Put the cover back in place and screw it on.
7.
8.
Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Problem
Possible cause Remedy/information
The oven door
The oven door
H
cannot be
is locked by
opened. The
self-cleaning.
symbol lights
up in the dis-
play.
The oven does
The oven is in
not heat up. The
demonstration
colon in the dis-
mode.
play flashes.
F8 appears in
Automatic
the display.
switch-off has
been activated.
'
)
x
Wait until the oven has
cooled down and the
symbol goes out.
Switch off the circuit
breaker in the fuse box and
switch it on again after
approximately 20 seconds.
Now, within approx.
h
2 minutes, press and hold
the
button for approx.
4 seconds until the colon
lights up continuously.
Turn the function selector to
the off position.
H

Advertisement

Table of Contents
loading

Table of Contents