Troubleshooting - moonboon MOTOR CONNECT User Manual

User Manual
Brugermanual
12 12
Moonboon slyngevugge
Motor Connect
T R O U BL E S H O O T I N G
MY MOTOR DOES NOT HAVE A BLUETOOTH BUTTON
If your motor does not have a bluetooth button located between the timer
and tempo knobs, you might have a Motor Original instead of Motor
Connect.
Please refer to the Motor Original user manual instead.
THE LED DOES NOT LIGHT UP
Check that the power supply is firmly attached to the top of the motor and
that the power is switched on. Turn off the power and wait 30 seconds
before turning it back on.
If the LED light still does not light up, the motor may need servicing. Please
contact customer service.
THE LED FLASHES RED AND GREEN
The Motor Connect indicates that you are not using a correct power
supply. Read more in the SAFETY CHECKLIST.
THE LED LIGHTS UP RED
The motor has gone into fail-safe mode and has stopped by itself as it
has detected an error. Reset the motor by turning both knobs to the off
position and then restart the operation.
If you repeatedly experience that the LED lights up red, this may indicate:
• There is not enough weight in the baby hammock or cradle. Read the
section on WEIGHT.
• If your Motor Connect hangs from the ceiling, you might have it
hanging in too long a strap. Read the section on WEIGHT.
• The motor is starting at too low a speed. Try starting the motor at a
higher speed and then reduce to the desired speed.