Table of Contents
Advertisement
!
WARNING
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface capable of
supporting the load.
• Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
• Lift only on areas of the vehicle as specified
by the vehicle manufacturer.
• Do not move or dolly the vehicle while on
the jack.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
WARNING: Do not use hydraulic jack as stand-alone device. After lifting, immediately support
!
the lifted vehicle with an identical pair of appropriately rated jack stands.
WARNING: Do not lift or carry jack by handle. Handle could dislodge and jack fall, resulting
!
in possible injury or property damage.
ASSEMBLY
Before Use
1. Assemble the 2-piece handle with
provided bolt.
2. Always secure the handle into the handle
fork by means of the bolt and lock washer
provided. Tighten securely to prevent
accidental removal of handle while in use.
3. Before using this product, read the
operator's manual completely and
familiarize yourself thoroughly with the
product and its components, and recognize
the hazards associated with its use.
4. Verify that the product and application are
compatible.
5. To familiarize yourself with basic operation,
locate and turn the release valve (pump
handle):
a. Clockwise until firm resistance is felt to
further turning. This is the 'CLOSED' release
valve position used to raise the saddle.
b. Counter-clockwise, but no more than 1/2
turn from the closed position. This is the
'OPEN' release valve position used to lower
the saddle.
6. With saddle fully lowered and release
valve closed, pump the handle. If lift arm
responds immediately, jack is ready for use.
SAFETY INSTRUCTIONS
ASSEMBLY
!
WARNING
To avoid crushing and related injuries:
• Never work on, under or around a load
supported only by hydraulic jack.
• Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower,
support nor move a house, mobile home,
travel trailer, camper or any building structure.
• Be alert and sober when using this product.
Do not operate under the influence of drugs
or alcohol.
Handle
(release valve)
Oil Filler Plug
(ref. Parts illustration for location)
Handle
Sleeve
If jack does not respond, follow Bleeding/
Venting Trapped Air instruction below.
Check oil level. Proper oil level will vary
from just covering the ram cylinder to 3/16"
above it as seen from the oil filler hole.
Reinstall oil plug.
7. Ensure that jack rolls freely. Raise and lower
the unloaded saddle throughout the entire
lifting range before putting into service to
ensure the pump operates smoothly. Replace
worn or damaged parts and assemblies with
authorized replacement parts only.
3
X
Lift Arm
Saddle
Front
Wheel
Caster
Advertisement
Table of Contents
