Selecting Programme Packages; Completing The Initial Commissioning Process - Miele PDR 914 SOM Operating And Installation Instructions

Skipping payment
device set-up

Selecting programme packages

You can select various programmes from the programme packages.
Any programmes already active are highlighted in orange.
Programme packages
Label Standard
Cottons  Cottons
Cottons PRO
Minimum iron
Swipe to the left with your finger until you reach a programme that is

not highlighted in orange.
Touch the programme to be activated.

The selected programme is now active and highlighted in orange.
You can select further programmes if required.
If you do not want to select any more programmes, confirm with

The display will change to the next setting.
Tip: You can disable a selected programme by touching the pro-
gramme again. Exception: The
grammes cannot be disabled.
Setting up a payment device
If you wish to set up a payment device, read the "Payment system"
section of the "Supervisor level" chapter. You can only make these
settings during initial commissioning. If you wish to change the set-
tings after the commissioning process, please contact the Miele Cus-
tomer Service Department.
If you do not wish to set up a payment device, you can skip this step.
Payment system
No payment
Timed
system
operation
Programme Timed op. +
control impul.counter
Touch the
No payment system

Touch OK to confirm.

The display will change to the next setting.

Completing the initial commissioning process

The commissioning process is complete when a programme lasting
longer than 10 minutes has been carried out in full.
en - Initial commissioning
11:02
Woollens
Delicates
OK
Cottons 
11:02
COM module
OK
sensor control.
and pro-
Cottons PRO
.
OK
69