Halo ULTRA PLUS Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Halo Manuals
  4. Water Filtration Systems
  5. ULTRA PLUS
  6. Installation instructions manual

Halo ULTRA PLUS Installation Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
R E V E R S E O S M O S I S S Y S T E M
Water Saver
Industry leading 50% recovery rate!
I nstallation & I nstruc tion M anual
Scan to learn more about
the HALO Ultra Plus
Smart Faucet
Blue light turns red
when it's time to
change the filters!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ULTRA PLUS and is the answer not in the manual?

Questions and answers

Related Manuals for Halo ULTRA PLUS

Summary of Contents for Halo ULTRA PLUS

  • Page 1 R E V E R S E O S M O S I S S Y S T E M Smart Faucet Blue light turns red when it’s time to change the filters! Water Saver Industry leading 50% recovery rate! Scan to learn more about the HALO Ultra Plus I nstallation & I nstruc tion M anual...

  • Page 2: Table Of Contents

    NOTE: Failure to comply with these installation instructions will void the product warranty, and the installer will be responsible for any service, repair or damages caused thereby. WARNING: DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION. HALO Ultra Plus Reverse Osmosis System...

  • Page 3: Initial Inspection

    HALO - safety tray water coolers, ice machines and other devices from the effects HALO - leak detector of water hammer. HALO system protection valve is NOT a pressure regulator. Static pressure will equalize with no flow HALO - system protection valve* through device.

  • Page 4: Operation Parameters

    (If the hardness of your water is above 7 gpg, lime scale will build up rapidly on the membrane. Scale buildup will plug the membrane and make the system ineffective. We do not recommend these reverse osmosis systems be used with water in excess of 7 gpg hardness, unless the water is treated prior to the reverse osmosis HALO system). •...

  • Page 5: Plumbing Schematic

    (Depending on water pressure) • Tank Weight: Full - 40 lbs. (Depending on water pressure) T50-NL - PLUMBING SCHEMATIC PLUMBING SCHEMATIC FOR REVERSE OSMOSIS SYSTEM (HALO Ultra Plus Reverse Osmosis System) RO FAUCET FAUCET BLUE TUBE ANGLE STOP ADAPTOR ALKALINITY FILTER...

  • Page 6: Pre-Installation

    RECOMMENDATION: Before drilling or grinding mask off the immediate area surrounding the grinding/drilling location preferably with duct tape or if duct tape is unavailable masking tape may be used. This procedure should help prevent scratching of the sink surface. HALO Ultra Plus Reverse Osmosis System...

  • Page 7: Faucet Installation

    Faucet I nstallation (Continued) REMOVE EVERYTHING FROM INSIDE THE SINK AND SURROUNDING AREA. Place paper towels in the sink to catch the shavings from the grinding and drilling. Using a cordless drill with a carbide grinding burr, gently grind away enough porcelain or enamel to more than accommodate the 7/16”...

  • Page 8: Angle Stop Valve Adaptor Installation

    1/4” Filter Tubing ANGLE STOP (White Tube) VALVE BODY 1/2” COMPRESSION NUTS 1/2” MALE TO 3/8” FEMALE COLD WATER LINE ANGLE STOP 3/8” THREAD ADAPTOR CONNECTION TURN OFF TURN OFF WATER FIRST! WATER FIRST! HALO Ultra Plus Reverse Osmosis System...

  • Page 9: Halo Leak Control Valve

    Place HALO leak detector into fixed position in tray and screw down. (If tray not use proceed to step 3). Place HALO leak detector 2 inches from side wall of cabinet and 4 - 6 inches from the drinking water systems inlet side.

  • Page 10: Drain Saddle Installation

    Drain S addle & Tank Placement Drain Saddle Diagram 5. INSTALLATION OF DRAIN SADDLE Drain Pipe Nuts Open the package containing the drain saddle. ( See DIAGRAM F ) Drain Clamp (Front plate) Peel the protective film off of the sponge Screw gasket.

  • Page 11: Unit Placement & Mounting

    Replace 3/8” line from above onto the angle stop valve adaptor male side and tighten accordingly. Insert one end of the extra piece of white tubing into the inlet of the angle stop adaptor. HALO Ultra Plus Reverse Osmosis System...
  • Page 12 Tubing & Q uick Connec t Fittings From the inlet of the angle stop adaptor connect the white tubing to the HALO system protection valve and ensure the flow arrow is in the correct direction towards the unit. CONNECTING THE TANK: (WHITE TUBING - From system tank port) Insert the white tubing from the RO system “Tank”...
  • Page 13 CAUTION!! IT IS RECOMMENDED THAT TUBING AND QUICK CONNECTION FITTINGS INSTALLATIONS ARE INSPECTED A MINIMUM OF ONCE PER YEAR AND PARTS REPLACED AS NEEDED. HALO Ultra Plus Reverse Osmosis System...

  • Page 14: System Start-Up

    Once no leaks have been determined. Lift the lever on the HALO leak detector valve and place compressed textile disc in holding cup and lower lever to allow water back into the system.

  • Page 15: Filter Replacement

    See page 13 (Section 8 & 9) two of the middle cartridges down with and tank valve (Turn handle for instructions. hardware provided. to horizontal position). Note: Remove towel/rag once system has run and no leaks have been found. HALO Ultra Plus Reverse Osmosis System...
  • Page 16 R eplacement Filters REVERSE OSMOSIS SYSTEM REPLACEMENT FILTERS 4 stage filtration, 5 Stage quality. Replace Filter: SEDIMENT Every year STAGE Five Micron Sediment Prefilter reduces dirt, sand, silt, sediment, and rust. Replace Filter: PRE-CARBON Every year Five Micron Coconut Shell Carbon Block Prefilter STAGE reduces chloramines, chlorine taste, and odor.

  • Page 17: Battery Replacement

    • PCB programing as 3 options: A. 2000 minutes or SIX months B. 2000 minutes or ONE year Batter y R eplacement C. 3000 minutes or ONE year Certifications INSTALLATION INSTRUCTION NCPS80CCDD-LEE (2000/06) ImportantNoticeOfRoutineMaintenanceAndCare Dimension Drawing • Occasional cleaningofaeratorisrecommended • Use ofsoapywaterandasoftspongeorclothisrecommended. •...

  • Page 18: Troubleshooting

    Replace drain flow restrictor. restrictor is clogged. No water to drain. Clear or replace drain line. Check valve on ro membrane Replace check valve. housing is stuck. The automatic shut-off valve is Replace automatic shut-off valve. malfunctioning. HALO Ultra Plus Reverse Osmosis System...
  • Page 19 Troubleshooting (Continued) LOW WATER PRESSURE FROM DISPENSING FAUCET POSSIBLE CAUSE / SOLUTION Open faucet and empty water from holding tank. Shut off feed water to system and remove holding tank from under sink. (The Air pressure in holding tank is tank is easier to work on).
  • Page 20 Water is shut off at stop valve Open main stop valve. (See diagram on page 15) HALO leak detector is set to off Make sure HALO leak detector main lever is in OPEN position. position Lever should be lowered. (See diagram on page 10)
  • Page 21 S er vice R ecord SERVICE RECORD SEDIMENT CARBON MEMBRANE ALKALINITY PH FILTER PRE-FILTER BOOSTER DATE (1 Year) (1 Year) (1 Years) (1 Year) NOTES Installation & Instruc tion Manual...
  • Page 22 REGISTER YOUR WARRANTY https://halowater.com/activate-warranty/ SCAN CODE BELOW...

  • Page 23: Liability & Warranty

    If a HALO Reverse Osmosis system was purchased from a 3rd party, liquidator or by any means other than an authorized licensed wholesale distributor, the warranty is void.
  • Page 24 R E V E R S E O S M O S I S S Y S T E M Change your water. Change your life. www.HALOwater.com • 800-591-0538...

Table of Contents

Save PDF