Table of Contents
Advertisement
Available languages
Available languages
Tape recording
Recording level
The recording level is strongly related to sound quality,
distortion, S/N ratio, frequency response, etc. When it is
very high, S/N ratio is improved but distortion and fre-
quency response are degraded. When it is too low, the
opposite results. The best recording levels can be deter-
mined by referring to the PEAK LEVEL meters. It is easy
to record a disk or FM broadcast because their sound le-
vel is limited to a certain extent. However, it is difficult
to set the recording level when recording live sounds or
when
recording from an open reel tape on which live
sound is recorded because the sound level varies within
a very wide range. The following general statements can
be made about setting recording levels.
Notes:— $$
1. The optimum recording level varies according to the sound source
and the type of tape. Find out the optimum recording level by re-
cording and playing several times.
2. PEAK LEVEL METER
readings during playback may differ from
those observed during recording. This is related to tape sensitivity
and is no problem.
Recording
1. Set the TIMER stand-by switch to OFF.
2. Set the POWER switch to ON.
3. Press the eject button (&) to open the cassette com-
partment and load a blank cassette.
A. Select Dolby NR with DOLBY NR switches.
5. Set the REVERSE
MODE
switch to normal
mode
( =>
) except when recording on both sides.
6. Press the REC/ARM
key and REC/PAUSE
key simul-
taneously.
. Adjust the recording level.
. Press REC/ARM key to start recording.
oN
How to leave a blank section
To obtain the best performance from DPSS, blank sec-
tions are essential. Leave blank sections as follows:
1. Press REC/ARM
key twice and the REC PAUSE indi-
cator flickers. .A blank sections of about 5 seconds is
left and the unit enters the rec pause mode and the
REC PAUSE indicator lights.
2. To leave a blank section of more
than 5 seconds,
keep the REC/ARM
key pressed the second time. A
blank section
equals
to the time the key is kept
pressed is left. When the REC/ARM
key is released,
the unit enters the rec pause mode.
3. To leave a blank section of less than 5 seconds, press
the REC/ARM key twice and press the REC/ARM key
again within 5 seconds. The unit enters the recording
mode. When the pause key is pressed after the REC/
ARM key has been pressed twice, the unit enters the
rec pause mode.
KX-76R(E}
9
Advertisement
Table of Contents
