Chapter 8 - Troubleshooting; Introduction; Status Messages - Xante FilmMaker 4 User Manual

Chapter 8 - Troubleshooting

Introduction

This chapter describes the status messages that can direct you to the source of a
problem, suggests solutions for some typical printer setup and print quality problems,
and provides information about preventing and clearing media jams.

Status Messages

Printer front panel window messages provide printer status information and can help
you determine the source of a problem or media jam.
EARLY PAPER JAM
E:FIFO
E:FIXING ROLLER
E:FUSER
E:LASER
E:MOTOR
EXIT PAPER JAM
FilmMaker 4
FRONT COVER OPEN The multipurpose feeder cover is open.
FRONT PAPER JAM
FULL STACK
FUSER COVER OPEN The fuser cover is not closed properly.
A media jam has occurred along the paper path caused by
media reaching a position earlier than expected.
The FIFO SIMM or SODIMM is not present, is not
properly inserted, or is broken.
There is a hardware problem with the fuser.
There is an error with the fuser, such as a temperature
inaccuracy.
There is a hardware problem with the laser.
There is a hardware problem with the motor.
A media jam has occurred after the media has been printed
but before it has been deposited in the output tray.
Appears when the printer is first turned on, before the
initialization process begins.
A media jam has occurred caused by the media not being
pulled from the tray properly.
The output tray is full.
Troubleshooting 8-1