Fujitsu ASBG18LF User Manual page 14

Cleaning the Intake Grille
1. Remove the Intake Grille.
1 Place your fi ngers at both lower ends of the grille panel,
and lift forward; if the grille seems to catch partway
through its movement, continue lifting upward to remove.
2 Pull past the intermediate catch and open the Intake
Grille wide so that it become horizontal.
2
1
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the unit with
warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1 Pull the knobs all the way.
2 Hold the grille horizontal and set the left and right
mounting shafts into the bearings at the top of the panel.
3 Press the place where the arrow on the diagram indi-
cates and close the Intake Grille.
Intake Grille
2
1
En-13
Intake Grille
2
1
Mounting shaft
Knob
Mounting shaft
2
Knob
1
Bearing
Cleaning the Air Filter
1. Open the Intake Grille, and remove the
air fi lter.
Lift up the air fi lter's handle, disconnect the 2 lower tabs,
and pull out.
Air fi lter handle
Hooks (2 places)
2. Remove dust with a vacuum cleaner or
by washing.
After washing, allow to dry thoroughly in a shaded place.
3. Replace the Air Filter and close the Intake
Grille.
1 Align the sides of the air fi lter with the panel, and push
in fully, making sure the 2 lower tabs are returned prop-
erly to their holes in the panel.
2 Close the Intake Grille.
(For purposes of example, the illustration shows the unit with-
out Intake Grille installed.)
● Dust can be cleaned from the air fi lter either with a vacuum
cleaner, or by washing the fi lter in a solution of mild deter-
gent and warm water. If you wash the fi lter, be sure to allow
it to dry thoroughly in a shady place before reinstalling.
● If dirt is allowed to accumulate on the air fi lter, airfl ow will be
reduced, lowering operating effi ciency and increasing noise.
● During periods of normal use, the Air Filters should be
cleaned every 2 weeks.
● Don't operate the air conditioner with being opened the
intake grille.
Hooks (2 places)