Pioneer CT-W801R Service Manual page 44

CT-W801R, CT-W851R, CT-W701R
(g) RELAY AUTO BLE
This will be relayed to side II after those for side I have been
completed by pressing the AUTO BLE key of side | in the
RELAY MODE ON, if BLE has not been adjusted for both sides I
and I]. The RELAY mode is released when adjustments for side
IJ start.
(h) Test Signal Frequency Switching
The test signal frequency switching is controlled in the following
way using two FSELO and FSELI port outputs.
For 2 POINT BLE, the 3 kHz control will not be performed.
(i) BLE related Port Output and BLE Data
400Hz |LEVEL *3/LEVEL * 2/LEVEL * 1/LEVEL * aon Ea DATA
ee ee
wx pepe tet! pe
[we [or [or [oe fore
ee
ee a eT
fo MA Eee |
Side I becomes 1 and side IT becomes 2 for *.
() indicates that for the metal tape.
The respective BLE DATAs of sides I and II can be checked on
the counter for any mode by pressing the 2-PAUSE +1-FWD
+2-FWD key simultaneously.
50
(j) AUTO BLE Time Chart
START
BLANK REC
Leader Path FF MASK PLAY
4 BLANK CHECK
MASK REC BIAS REC 1.2 SEC ft RISING CHECK
- Le, Q@LEADER TAPE CHECK
1.5SEC O.5SEC : < > indicates the 2 point
i AUTO BLE
Rewind PLAY :
2.95 SEC (=1.2 +1.50 +0.25)
BIAS CHECK PLAY
15SEC TT : LEVEL REC 1.7 SEC
05sec ;
Rewind PLAY
3.45 SEC (=1.7 +1.50 +0.25)
LEVEL CHECK PLAY
15SEC tT i EQREC 13 SEC om 9 SEC)
Seen rea
0.5 SEC
3.05 SEC (=1.3 +1.50 +0.25)
(2.65 SEC (=0.8 +1.50 +025)
EQ CHECK PLAY
>
1.5 SEC tt Th
Rewind (MS-)
END
BIAS REC LEVEL REC
400Hz 16STEP—UP
oe E DATA 0
REF. UNDER OVER
O.2see Ost sec
EQ REC
1OkHz 8STEP —UP
7 DATA _O
Soa iis Stee ms
0.2sec 0.1sec 0.2sec
3kHz is not recorded and played back for 2 POINT BLE.