Problems/Causes/Remedies - Janser Tiger Use And Maintenance Manual

PROBLEMS
Insufficient cut
Insufficient motor
eed
Grooved work
surface
Insufficient dust
collection
The motor does not
start
Burns on the work
surface
_______________________________________________________________________________________________
BELT-SANDER FOR WOODEN FLOORS
CAUSES
worn or unsuitable abrasive
insuffiecient roller pressure
roller belt tension insufficient
worn roller belt
insufficient voltage due to:
excessive length or unsuitable cable
cross-section
precarious connections
faulty running capacitor
faulty motor
faulty belt
dirty or faulty roller surfaces
incorrect wheel adjustment
dust bag over one-third full
dust bag dirty or with closed pores
intake and or outlet ducts blocked
faulty safety switch or contactor
faulty startup capacitor
insufficient voltage due to
precarious connections
faulty motor
no mains supply voltage
worn abrasive
excessive roller pressure
excessively fine abrasive
TIGER
REMEDIES
replace abrasive
increase roller pressure, see pg. 13
increase belt tension, see pg. 10
replace belt
use cable of suitable length and cross-
section
set up suitable connections
contact an authorized JANSER distributor
contact an authorized JANSER distributor
replace the belt
clean the outer surface of the tensioner
clean, straighten or replace the rubber-
coated roller
correct their position, see pg. 11
empty out the contents of the bag
shake out the bag and wash it
clean the air ducts
contact an authorized JANSER distributor
contact an authorized JANSER distributor
contact an authorized JANSER distributor
contact an authorized JANSER distributor
check the power supply and connections
replace abrasive
decrease sanding pressure, see pg. 13
use a coarser abrasive
ED 95
PG. 15/16
INSTRUCTION MANUAL