ENGINEERING PRODUCTS POWER KING 1620 Owner's Manual page 9

LH Button RH Button
Controls Reverse Controls Forward
"Bypass Valves"
INSTRUMENT GROUP
HOUR METER runs when ignition switch is "ON".
Do not leave ignition "ON" when engine is not run-
ning. Use hour meter to perform timely maintenance.
VOLT METER senses battery condition. With igni-
tion switch on, but engine not funning. 12-14 volts of
battery charge is normal.
ENGINE TEMPERATURE LIGHT normally off. Only
goes on if engine head temperature is excessive.
LOW OIL PRESSURE LIGHT. Detects low oil pres-
sure. During starting sequence this light should be
"ON" when the ignition switch is "ON" but the engine
is not running.
LIFT CONTROLS
THE HYDRAULIC LIFT CONTROL LEVER is located
on the lower right side of the dashboard. The lever is
connected through the dashboard sheet metal to a
single-spool hydraulic control valve, and has four
10
operating positions: (1) "Hold" position is in the
center. (2) Pulled to the rear, both front and rear
mounted implements will be raised. Released, the
lever will automatically return to its center position
and the implements will hold their raised position. (3)
Pushed forward, both frontand rear implements will
be lowered and, again, the lever will return to its
center position when released. And (4) Pushed fully
forward, through a slight detent, will allow the
implements to "float," or seek their own best oper-
ating level. In this case, the lever will remain in the
forward position until pulled out of the detent.
An auxiliary lift kit is also available which, when
installed in addition to the standard hydraulic lift
system above, will allow rear mounted implements
to be raised or lowered separately and independ-
ently of front or mid-mounted implements. Control
lever action is the same as described above.
Lift
Decal