Advertisement
Pedestal Installation
1. Remove the front and rear
covers of the pedestal.
2. Turn controller power off.
3. Detach all cables (B and C)
from old modem assembly.
4. Remove four mounting
screws (A) and old board
assembly (D).
5. Install new board assembly
(D) with four mounting
screws (A).
Check that the new modem
board's jumper is set to VP
(see Figure 1).
6. Reconnect cables (B and C).
7. Turn controller power on
and check communications
with central.
8. Close and secure front and
rear panels.
Kit Components
•
one (1) board assembly
Important Notifications
CAUTION: LAC serviceable parts shall be installed by qualified personnel familiar with the product and with local
!
electrical code requirements. LAC serviceable parts shall not be used or installed in product other than LAC
Product Series. Failure to do so will void product's safety and FCC certification.
If used in product other than LAC Product Series, additional safety and FCC testing shall be considered as part of
the end product assessment and usability.
©2023 The Toro Company • www.toro.com
WARNING: Cancer and Reproductive harm – www.P65Warnings.ca.gov.
!
For more information, please visit www.toro.com/CAProp65.
Patent: www.ttcopats.com
Tools Needed
•
Philips head screwdriver
5825 Jasmine Street
Riverside, CA 92504
800-777-1477
irrigationsupport@toro.com
Part Number 373-1103 Rev. A
Advertisement
