Pioneer CDJ-1000 Service Manual page 54

CDJ-1000
7.1.4 Part Replacement Method of JOG Section
7.1.4.1 A part to Replace in Part Replacement Simultaneously
Replacement Part
Sheet SW {JOG Sheet A] JOG Sheet B|JOG Sheet C| JOG Plate {| JOG Holder | JOG Dial A | JOG Dial B
(DSx1087) | (DXB1757) | (DXB1757) | (DXB1757) | (DAH2052) | (DNK3872) | (DNK3870) | (ONK3871)
JOG Dial A
JOG Dial B
Note MEE: Do not need to replace the JOG Holder when replacing the Sheet SW. However, be careful so that paste
does not remain on the former Sheet SW.
7.1.4.2 Caution in Sheet SW Installation
@® Be careful not to bend and fold the Sheet SW.
@ Contirm that the dust or trash does not adhere to pasting side
JOG Panel (JOG Holder).
In addition, when tear off the former Sheet SW and put a new
JOG Plate part, completely wipe the JOG Holder off with alcoho! so that
paste does not remain on the pasting side of JOG Holder.
® Bend a cable of the Sheet SW in a right angle in difference in
grade oo and put it in corner hale of the JOG Holder.
(Fig. @)
@ When put the Sheet SW, match the position not to run aground
JOG Dial A on rib of the internal circumference of JOG Holder. (Fig. @)
@® Sheet SW pushes all the sides including the point of contact
fully, and put it. (No good air getting into it.)
® When insert a cabie in connector, release a lock by all means,
and connector locks after inserting it.
© A cable performs styling as shown in Fig. @ after installing the
JFLB Assy (DWG1549).
JOG Sheet A
Fig. @ Fig. © (Bottom View)
@® It assembles so that an encoder plate may go into the slot of the
'- \cceee oe a = |
Encoder Plate = <= a v : zi , : 7
CO
;
: ame bp
|
s s B s se encoder plate
JFLB Assy A > ae i , JOGB ASSY
Fig. 1 JOG Section View < - { Sectional view ]
66
CDJ-1000
7.1.4.3 Caution in JOG Sheet A Pasting
@ Be careful not to bend and fold the JOG Sheet A.
@: Put a lubricant (GEM1038) on the sheet.
@ Confirm that the dust or trash do not adhere to pasting side (JOG Dial A).
» Match JOG Sheet A with marking of inner and outer circumterence for pasting of JOG Dial A. (Fig. @)
: Put it to push you out of the inner circumference toward the periphery. (No good air getting into it.)
(oy (B) 6
JOG Sheet A
JOG Dial A
Fig. @ (Bottom View)
7.1.4.4 Caution in JOG Sheet B Pasting
D Be careful not to bend and fold the JOG Sheet B.
Zi Put a lubricant (GEM1038) on the sheet. :
2: Confirm that the dust or trash do not adhere to pasting side (JOG Holder).
Pasting method: Two places have this side with 90°. Paste it while matching with a guide of rib, and match a round. (Fig. @)
Put it to push you out of the inner circumference toward the periphery. (No good air getting into it.) (Fig. @)
U1) fe}
JOG Sheet B
JOG Sheet B
It unites with the rib of
an inner circurnterence.
Fig. @ Fig. @
67