Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Maytronics Dolphin SX30
Summary of Contents for Maytronics Dolphin SX30
- Page 1 Robotic Pool Cleaner SX30 8151668 Ver. 01 12/2015...
-
Page 2: Table Of Contents
Robotic Pool Cleaner SX30 User Instructions Contents 1. INTRODUCTION ..............2 2. SPECIFICATIONS ..............2 3. WARNINGS AND CAUTIONS ..........2 3.1 Warnings ................2 3.2 Cautions ................2 4. POOL CLEANER PARTS ............3 5. USING THE POOL CLEANER ........... 4 5.1 Setup .................. -
Page 3: Introduction
1. INTRODUCTION Thank you for purchasing a Maytronics Robotic Pool Cleaner. We are sure that your Maytronics Robotic Pool Cleaner will provide you with reliable, convenient and cost-effective pool cleaning. Its reliable filtration in all pool conditions and active brushing, enhance pool hygiene. -
Page 4: Pool Cleaner Parts
4. POOL CLEANER PARTS Robotic Pool Cleaner SX30 Power supply options Filtration options Caddy kit - optional Robotic Pool Cleaner SX30 User Instructions... -
Page 5: Using The Pool Cleaner
5. USING THE POOL CLEANER 5.1 Setup Before using the Pool Cleaner for the first time, perform the following steps: 3m/10ft 5.1.1 Position the power supply 5.1.2 Unwind the cable and stretch it out completely so that it has so that it is approximately in the no kinks. -
Page 6: Putting The Pool Cleaner Into The Pool
5.2 Putting the Pool Cleaner into the pool 5.2.1 5.2.2 Put the Pool Cleaner into the pool. Turn the power supply ON. Release the Pool Cleaner and let it sink to the floor The Pool Cleaner will now operate until it has of the pool. -
Page 7: Removing The Pool Cleaner From The Pool
5.4 Removing the Pool Cleaner from the pool Turn OFF and unplug the power supply. CAUTION 5.4.1 5.4.2 Using the floating cable, bring the Pool Cleaner to the pool’s edge. Using the handle, remove the Pool Cleaner from the pool. DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE. -
Page 8: Cleaning The Dual Filter Basket
6. CLEANING THE DUAL FILTER BASKET Make sure the power supply is switched off and unplugged. CAUTION It is highly recommended to clean the filter basket after each cleaning cycle. Note: Do not let the filter panels dry out before cleaning. 6.1 Cleaning after use - removing and cleaning the dual filter basket 6.1.1 6.1.2... -
Page 9: Periodic Filter Cleaning
6.2 Periodic filter cleaning – recommended at least once a month Dismantle the 4 ultra-fine filter panels of the outer basket, according to the following steps: 6.2.1 6.2.2 6.2.3 Holding down the Dismantle the panels, Continue to dismantle handle, remove the inner starting by pressing on the panels in the order of their numbers: 2 —... -
Page 10: Cleaning The Impeller
6.3 CLEANING THE IMPELLER 6.4 If you notice debris trapped in the impeller: Make sure the power supply is switched off and unplugged. CAUTION Clean the debris trapped in the impeller opening, according to the following steps: 7.1.1 7.1.2 7.1.3 7.1.4 Robotic Pool Cleaner SX30 User Instructions... -
Page 11: Off-Season Storage
6.5 Assemble the impeller compartment according to the next steps: 7.2.1 7.2.2 7. OFF-SEASON STORAGE If the Pool Cleaner will not be in use for an extended period of time, perform the following storage steps: • Make sure that no water is left in the Pool Cleaner •... -
Page 12: Troubleshooting
8. TROUBLESHOOTING If the suggested solutions do not solve the problem, please contact your dealer or Service Center. Symptom Possible reason Corrective action The power-supply • No voltage in the power socket in the wall. • Check that there is voltage in the power socket in the wall. or its switch led •... - Page 13 Robotic Pool Cleaner SX30 8151668 Ver. 01 12/2015 www.maytronics.com...
Need help?
Do you have a question about the Dolphin SX30 and is the answer not in the manual?
Questions and answers