Advertisement
3.
Start Device Discovery, and select your PVCA 452 device from the list (use the MAC address to locate the desired device).
Enter credentials, if required.
4.
Use the Set IP feature in the Toolbelt software, or use the Toolbelt Manage > Network Settings tab to set the IP address or
host name, subnet, gateway IP address, and related settings.
NOTE:
If using a host name instead of an IP address, the user must enter a qualified host name
(Username.HostName.Domain). For example: somename.somedomain.com.
5.
Using GC, create a new GC Plus or GC Professional project and configure the PVCA 452:
a.
Configure the control ports.
b.
Select device drivers and link them to each assigned serial, IR, or Ethernet port.
c.
Configure settings (serial protocol, relay behavior, digital input, volume control settings) as needed.
d.
Add and configure control interface (eBUS, TouchLink Pro, etc.).
e.
Set up monitors, schedules, macros, and local variables.
6.
Save the project.
7.
Build and upload the system configuration to the controller.
Application Diagram
Di
Display
Display
PC
For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the
Safety and Regulatory Compliance Guide
6
GVCCS
LAN
l
HDMI
HDMI
A B C
Extron
WPD 110 A
HDMI Pass-Thru
Line Output Audio
on the Extron website.
© 2023 Extron — All rights reserved.
All trademarks mentioned are the property of their respective owners.
Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876
PVM 220
PLENUM VAULT
Audio
RS 232 (Display Control)
CONFIG
R
e
Extron
PVCA 452
VoiceLift Amp
eBus
DISPLAY
DISPLAY
ON
ON
OFF
OFF
VOLUME
VOLUME
Extron
Extron
Extron
Extron
EBP 100
EBP 100
www.extron.com
Extron
FF 120T
Extron
FF 120T
Audio
Audio
PAGE
eBUS
COM
IR/S
I/O
CEC
SENSOR
L
1000
LIMIT
B
Tx
1
LINK
E
Rx
2
ACT
OVER
PVCA 452
Audio
VLR 302
LINK
1
R
CONFIG
2
Extron
VLR 302
PC
PC
LAPTOP
MUTE
Extron
68-3603-50 Rev. B
11 23
Advertisement
