Set Up - Standalone Installation; Using The Dehumidifier Display - Seaira Global WatchDog NXT120c Installation And Operation Manual

Set Up - Standalone Installation

It is also possible to use the dehumidifier without any ducting.

Using the Dehumidifier Display

Note: While connected to the HVAC system, display functions on the dehumidifier will not work.
1. Power Key
a. Use this button to turn the dehumidifier on and off.
b. Press once to turn the machine on. You will hear two beeps and the
light will illuminate green (solid or flashing depending on mode).
c. Press the power button a second time and you will hear one beep as the
machine shuts down. Note that there is a one minute fan delay.
2. Arrow Buttons
a. Use the up and down arrows to set the desired humidity setpoint on the
display screen.
b. The setpoint can be any number between 36% - 90%. When the indoor
humidity is higher than the setpoint, the unit will operate.
c. Keep in mind that the displayed humidity levels are approximate (+/- 5%)
3. Continuous Mode
a. To set the unit to run continuously, regardless of humidity, simply use the
down arrow to set the humidity below 36%.
b. The continuous light will illuminate green and the display will show "CO".
c. To switch back to normal humidistat operation, use the arrow keys to
move the setpoint above 36%
4. Manual Drain Button
a. If you need to store or move your dehumidifier, press the "drain" button to
remove water from the pump's reservoir.
5. Pump Trouble Warning
a. If the pump reservoir level gets too high, the water sensor will activate to
prevent overflow.
11