Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for Laser Tools 5931
- Page 1 5931 Coil Spring Compressor (Internal type) Instructions www.lasertools.co.uk...
- Page 2 Introduction To compress the suspension coil spring when the spring is fitted independently of the suspension damper (wishbone, independent and multi-link systems) and access is possible from the bottom of the spring. The dimensions of the tool will allow access through lower wishbone holes as small as 30mm in diameter.
- Page 3 Instructions IMPORTANT: You must refer to the manufacturer’s service instructions or documentation to establish the correct procedures for removing the coil spring and/or damper units. The following notes and diagrams are provided as a guide only. No liability is accepted for incorrect use of this product.
- Page 4 WARNING: To prevent equipment damage and possible injury when fitting the 5931 to a tensioned spring always ensure the cups are positioned to allow the force screw thread to remain engaged by a minimum of 3 full turns at the free length of the spring.
Need help?
Do you have a question about the 5931 and is the answer not in the manual?
Questions and answers