Related Manuals for EcoSmart LR411U-2.4X7IR-3M-1024
Summary of Contents for EcoSmart LR411U-2.4X7IR-3M-1024
- Page 1 Item #1009 525 844 Model #LR411U-2.4X7IR-3M-1024 9.8 ft WHITE RECHARGEABLE BATTERY STRIP LIGHT WITH MOTION SENSOR...
- Page 2 Table of Contents ........Installation ........5 Safety Information ......... Operation ..........8 Warranty ..........3 Care and Cleaning ......Pre-Installation ........4 Read and understand this entire manual before you attempt to install or operate this product. □ This strip light is intended for indoor use only. □...
-
Page 3: Warranty
This warranty shall not apply to the nish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. Contact the Customer Service Team at 1-800-910-7164 or visit www.HomeDepot.com/EcoSmart. - Page 4 Contact the Customer Service Team at 1-800-910-7164 or visit www.HomeDepot.com/EcoSmart. Part Description Quantity Strip light Rechargeable battery with controller USB charging cable Remote control Iron sheet Mounting clips Screws...
- Page 5 Prepare the strip light (optional) Shorten the strip light (A) to the desired length by cutting along the black lines.
-
Page 6: Install The Controller
Install the strip light Ensure that the mounting location is even, clean, and dry. Remove the protective film from the back of the strip light (A). Press the strip light (A) to the mounting surface and hold in place for a few seconds. Install the controller Remove the protective film from the back of the iron sheet(E) Press the iron sheet(E) to the mounting surface and hold... - Page 7 Use the mounting clips(F) to further secure the strip light(A). Note: Use the screw to secure the installation and avoid strip light falling down when adhesive lose viscosity...
-
Page 8: Remote Operation
Remote Operation CAUTION: The remote control included utilizes a 3V CR2025 battery; Do not dispose of batteries in fire as they may explode or leak. Please dispose of used batteries immediately and safely. Only replace with the same battery type. Examine devices and make sure the battery compartment is correctly secured, e.g. - Page 9 Operation(continued) Button Description ON: Press to turn on the light OFF: Press to turn off the light Adjustable brightness: Increase or decrease the 10-level of light brightness Adjustable speed: Increase or decrease the 10-level speed of dynamic mode Fade mode Flash mode Adjustable brightness: 100%, 75%, 50%, 25% Motion mode:...
-
Page 10: Controller Operation
Operation(continued) Controller Operation WARNING: Do not try to replace the lithium polymer battery. The rechargeable battery in controller is not replaceable. NOTE: 1. The controller is rechargeable and detachable. Get the controller fully charged before use it. 2. When the remote and the controller set the motion mode together, the nal effect depends on the last command... - Page 11 Operation(continued) Description IR Remote PIR Motion Receiver Increase the 10-level of light brightness Press to turn on/off the light Decrease the 10-level of light brightness Motion Sensor Mode: [Motion Sun Mode] Light turns on when get detected [Motion Off] [Motion Moon Mode] Light turns on in darkness only when get detected Delay Time Options: Light remains on for 120s, 60s or 15s when not get detected Strip light connection port USB charging port...
Need help?
Do you have a question about the LR411U-2.4X7IR-3M-1024 and is the answer not in the manual?
Questions and answers