Advertisement
Care for main body
●
Wipe off the toner/moisturizing product on the head and the body with a tissue.
When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and
wring it thoroughly.
Do not clean the main body with water. Or do not dip in water,
and do not pour water. (Cause of failure)
Make sure to turn OFF the switch. (Improperly turning on the switch
may give a tingling sensation or result in malfunction or short-circuit.)
★Do not use alcohol, benzine, or thinner.
CAUTION
(Cause of deformation or discoloration)
How to preserve
Store the device on the included stand in a place free from excessive humidity or dirt.
The stand can store the rings in it as well as put the body on it. (Fig. 12)
Do not leave in a water splashing area or an area with significant
humidity, such as a bath. (Cause of short-circuits or failure)
★Do not leave in an area subject to direct sunlight (inside of a vehicle in
CAUTION
summer, etc.) or near heaters. (Cause of deformation or discoloration)
Specifications
Power adaptor
Power
(KH-182B)
supply
Main body
Charging time
Rated time
Accessories
Disposal of the product
Do not disassemble except when disposing of the product.
This product includes recyclable parts.
For disposal of the parts, observe your local laws and regulations etc.
How to remove the nickel-hydrogen batteries
1. Keep pressing the power switch continuously while it is "ON" for about 10 seconds or
more to make the device vibrate and leave it until the vibration stops.
2. Remove the two screws on the reverse side of the main body. (Fig. 13)
3. Insert a flat-blade screwdriver or the like in the gap between the main body cases (front)
and (rear), and remove the main body case (rear). (Fig. 14)
Flat-blade screwdriver
4. Cut the lead wires connected to the terminals of the nickel-hydrogen batteries near the
terminals, and take out the batteries from the battery holder. (Fig. 15)
Main body case (front)
Do not allow the (+) and (-) terminals of the removed nickel-hydrogen
batteries to make contact. (Cause of a short circuit or burns)
100 - 240V AC, common to 50-60Hz
Batteries [Nickel-hydrogen battery (1.2V DC, 500mAh×2)]
5 hours as standard
Around 15 minutes at the maximum
(basic mode:approximate 10 minutes)
Rings (two), stand
Main body case (rear)
Lead wires
Get other manuals https://www.bkmanuals.com
Nickel-hydrogen batteries
-12-
Screws
Battery holder
Advertisement
