Pioneer CLD-3070 Operating Instructions Manual

Operating
Instructions
Wee eé
ISG CD >
DIGITAL AUDIO
WPIONEER co cov a aves CLD-3070
CD CDV LD PLAYER
CLDO-3070
NTSC
LaserVision
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of con-
necting and operating the unit is the same.
WARNING:71o PREVENT FIRE OR SHOCK HAZ-
ARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep it in a secure area. This is for your
security.
[For Canadian model]
CAUTION:10 prevent ELECTRIC SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION:rour preveniR Les cHOocS
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU
UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with
this switch. U.S., Canadian, European, U.K.,
and Australian models are not provided with
this switch.
Mains voltages in Saudi Arabia are 127V and
220V only. Never use this model with 110V
setting in Saudi Arabia.
A 4-point (110V/120-127V/220V/240V) or (110V/120V/
220V/240V) voltage selector switch is located on the
rear panel of the player. Check that it is set properly
before plugging the power cord into an AC outlet. If
the voltage is not properly set or if you move to an
area where the voltage supply differs, adjust the
selector switch as follows:
1. Disconnect the power cord.
2. Use a medium-sized (flat blade) screwdriver.
Insert the tip of the screwdriver into the groove
of the selector switch and turn it to set the player
to the power voltage of your area.
Point arrow to
power voltage of
a your area (Figure
i shows arrow
a pointing to 240
volts.)
Y) PIONEER'
The future of sound and vision.
refs ESE ECO SEES TS ESL SEES EIT SBS OE EE TE ETERS EE TEES ES ESN EEL TEETER EEE EEE EES SIRES ELECT ENCE EEE EE TELE SE SEE LEER EEL EESTI LEE ALE I E
RUT I EES ERR OSA SSE EOP EP TSR PEE ES SE CE TE EI SIT ITT EET TEI TT NTE