Operations; Protection Shield Introduction - Milestone MAXI-44 eT User Manual

Milestone Srl
GETTING STARTED GUIDE

4 OPERATIONS

4.1 Protection shield introduction

The below operations must be carried out only after Milestone specialist indications.
Once the shields have been installed, it will no longer be necessary to remove them from the rotor
body.
Shift the silicon protection ring on the lower
side of the protection shield.
The protection ring must be located on the
opposite of the tapered side.
Place the protection shield in the notch on the
bottom plate. The taper should be placed with
the face up.
Once introduced all the protection shields, place
the centering plate and screw it with its four
screws. Be careful that the marks (black points)
coincide.
MA210-002 – MAXI-44 eT – User Manual
11