Location And Installation; Safety Precautions; Installation - Frosty Factory 117A Owner's Manual

2.1 SAFETY PRECAUTIONS

Do not attempt to operate your Frozen Drink Machine until the safety precautions and
operating instructions in this manual are read completely and are thoroughly understood.

2.2 INSTALLATION

Placing your Frozen Drink Machine in a highly visible area will enhance sales.
CAUTION: Do not attempt to share the dedicated electrical outlet with any other
appliance; this will cause the circuit breaker to trip.
1. Remove the machine from the shipping container.
2. Place the unit on a sturdy platform able to hold the weight of the machine when full of
product. (Usually about 150 #)
3. Level the machine by turning the adjustable part of the leg. The machine must be level
front to back as well as left to right.
4. Air-cooled condensers must have correct ventilation. Air intake is at the rear of the
machine and discharge through the side; 24" clearance is required on both sides and
8" at the back. In addition, all Frozen Drink Machines require 12" clearance above
the machine.
NOTICE: Locating the unit in direct sunlight, near cooking equipment or any high
heat area will reduce the performance of your machine.
CAUTION: Extended operations under severe heat condition can damage the cooling
system.
NOTICE:
Establishments that serve beverages from frozen drink machines are
responsible for providing the necessary facilities for cleaning and
sanitizing their food service equipment.
5. Place the three-position switch in the OFF position (center).
6. Connect the power cord. The Frozen Drink Machine must be connected to a properly
grounded receptacle. The electrical cord furnished as part of the Frozen Drink
Machine has a three prong grounding type plug. The use of an extension cord is not
recommended. If one must be used, refer to the national and local electrical codes.
Do not use an adapter to get around grounding requirements.
WARNING: Do not
attempt to alter the
electrical plug. Serious
injury or electrocution
may result.
7. Install the drip tray, cover, beater bar and
faceplate assemblies on the Machine.
SECTION 2
LOCATION & INSTALLATION
Notice: Your
receptacle should
look like this.
5
230V 115V
20A 20A
115V
15A