Kenwood KR-V6040 Instruction Manual page 7

@ Push lever down. @ Insert cord. @ Lock lever.
dl €
Front speaker terminals for Europe
@® Turn counterclock- @Insertcord. @ Lock knob.
wise to loosen.
@ Never short-circuit the + and - speaker cords, .
@ If the left and right speakers are connected inversely or if the" becomes unnatural with ambiguous acoustic image positioning. |
speaker cords are connected with reversed polarity, the sound Be sure to connect the speakers and speaker cords correctly.
M Setting the SPEAKER IMPEDANCE SELECTOR
| When using the speaker A or speaker B separately According to the impedance of the speakers used, set the |
= SPEAKER IMPEDANCE SELECTOR on the rear panel as shown |
Speaker Impedance Selector position
in the table.
Kor 8: LESS THAN
82 OR MORE @ When the IMPEDANCE SELECTOR switch is set to "8 Q OR
MORE', it is impossible to use the A and B speakers at the
same time.
When using the speaker A and B simultaneously Therefore, when using the speakers A and B simultaneously,
Speaker Impedance be sure to set the IMPEDANCE SELECTOR switch to the 'A
0160 Az , OR MORE and B: 8 Q OR MORE' position.
and B: 8 OR MOR @ During speaker system connection and operation of the
SPEAKER IMPEDANCE SELECTOR, set the POWER key to
OFF.
(MPEDANCE SELECTOR
AorB:
LESS THAN 89 AorB:
4andB:89 OR MORE "ais 8&0 OR MORE
Lol
—
KR-V6040 (En) 7