Advertisement
2—5. Removing the power source circuit board
Remove the screws (
and (i) ) indicated in Fig. 6,
and the power source circuit can be removed.
2—6. Replacing the fuses
Fuses are installed in the positions ( (2 and (3 ) in
Fig. 6. According to 2—1 and 2—5 above, remove the
print circuit board.
The fuse capacity is 0.8 A for
(2 and 1.8 A for
3 .
Before replacing a fuse, be sure to check the cause of
fuse burning.
3. Mechanism Parts
@)
08
8 B®
O®
4) 8) WE)
9d) @
Fig. 7
3-1. Removing the Motor (Figs. 8 and 9)
1) Desolder the motor wires (red and black)
2) Remove
the two screws (@)) and 62 ) holding
the motor @ to the motor bracket.
The motor
can be removed.
3—2. Removing the Flywheel (Figs. 7 and 8)
1) Remove
the screws ( @3) and
@4 ) securing the
lever
@) locking
the
casette
holder
@).
Then
remove
the
screws
(@5
and
), and
the
flywheel holder () can be removed.
2) Remove
the "E"' ring, and pull out the take-up
idler arm (6).
3) Remove
the capstan belt @, and pull out the
flywheel @). The flywheel now can be removed.
3—3. Removing the Plunger (Figs. 7 and 8)
1) Remove the screw @7 and nut
securing the
plunger (9) and slide bar
together.
2) Remove the two screws ( 69) and
) securing
the plunger to the bracket
()), and the plunger
can be removed.
Advertisement
