Specifications - Crown Micro-Tech 1200 Operation Manual

Micro-Tech Series Power Amplifiers

8 Specifications

Minimum Guaranteed Power
120 VAC, 60 Hz Units, Stereo mode, per channel, both channels driven
1 kHz with 0,1% THD
Stereo, 2 ohms (per ch.)
Stereo, 4 ohms (per ch.)
Stereo, 8 ohms (per ch.)
120 VAC, 60 Hz Units, Bridge mono mode
1 kHz with 0.1% THD
Bridge mono, 4 ohms
Bridge mono, 8 ohms
Bridge mono, 16 ohms
120 VAC, 60 Hz Units, Parallel mono mode
1 kHz with 0.1% THD
Parallel mono, 1 ohm
Parallel mono, 2 ohms
Parallel mono, 4 ohms
Performance
Frequency Response (at 1 watt, 20Hz - 20 kHz)
Phase Response (at 1 watt, 20Hz - 20 kHz)
Signal to Noise Ratio below full bandwidth power
20 Hz to 20 kHz
A-weighted
Total Harmonic Distortion (THD) at rated power, from 20 Hz to 20 kHz
Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1,
from 163 milliwatts to full bandwidth power
Damping Factor: 10 Hz to 400 Hz
Crosstalk (below rated power, 20 Hz to 20 kHz)
Common Mode Rejection (CMR) (20 Hz to 1 kHz)
DC Output Offset (Shorted input)
Input Impedance (nominally balanced, nominally unbalanced)
Load Impedance (Note: Safe with all types of loads)
Stereo
Bridge Mono
Parallel Mono
Operation Manual
MT-600
400 W
325 W
220 W
750 W
655 W
450 W
700 W
665 W
450 W
MT-600
± 0.1 dB
±10°
>100 dB
>105 dB
0.1%
< 0.05%
>1000
> 61 dB
> 70 dB
±10 mV
20 k ohms, 10 k ohms
2-16 ohms
4 -16 ohms
1-4 ohms
MT-1200
675 W
480 W
310 W
1,300
970 W
620 W
1,300 W
965 W
620 W
MT-1200
± 0.1 dB
±10°
>100 dB
>105 dB
0.1%
< 0.05%
>1000
> 61 dB
> 70 dB
±10 mV
20 k ohms, 10 k ohms
2-16 ohms
4 -16 ohms
1-4 ohms
MT-2400
1,050 W
800 W
520 W
2,070 W
1,585 W
1,035 W
2,080 W
1, 605 W
1, 035 W
MT-2400
± 0.1 dB
±10°
>100 dB
>105 dB
0.1%
< 0.05%
>1000
> 61 dB
>70 dB
±10 mV
20 k ohms, 10 k ohms
2-16 ohms
4 -16 ohms
1-4 ohms
page 19