Table of Contents
Advertisement
DIN Rear-mount
Installation using the screw holes on
the sides of the unit
1.
12.
13.
14.
15.
16.
Le
10
Remove the frame. (Fig. 9)
Frame
Insert the release pin into the hole in the
bottom of the frame and pull out to remove
the frame.
(When reattaching the frame, point the side
with a groove downwards and attach it.)
. Fastening the unit to the factory radio
mounting bracket. (Fig. 10) (Fig. 11)
Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use either
truss screws (5 x 8 mm) or flush surface
screws (5 x 9 mm), depending on the shape of
the screw holes in the bracket.
Screw
Factory radio mounting bracket
Dashboard or Console
Fig. 9
Fig. 10
Fig. 11
Advertisement
Table of Contents
