Replace Cinch™ Connectors - Worldwide Construction And Forestry Division 35D Technical Manual

Replace CINCH™ Connectors
1. Remove extraction tool (1) from the loading side of
connector.
2. Insert blade of extraction tool into locking tabs (2)
of secondary lock (3). Rotate tool away from the
CINCH™ connector to pry one side of the secondary
lock out of the locked position. Repeat this step for
the other locking tab.
NOTE: After unlocking one side of the secondary
lock, a screwdriver or similar device may be
used to hold it in the unlocked position while
unlocking the second locking tab.
1— Extraction Tool
2— Secondary Lock Locking
Tabs
CINCH is a trademark of the Cinch Co.
3. Remove secondary lock (3).
3— Secondary Lock
4. Insert pointed side of extraction tool (1) into the contact
cavity so that the flat side of tool faces secondary lock
cavity (4). This will release the primary contact locking
tab.
5. Pull wire out of the connector.
6. Replace terminals as necessary. See Install CINCH™
Contact. (Group 9015-20.)
7. Insert contact and wire into connector until it clicks.
8. Install secondary lock.
1— Extraction Tool
TM2263 (09JUL14)
References
3— Secondary Lock
4— Cavity
9015-20-25
CS33148,0002A8E -19-08JUL08-1/3
Remove Secondary Lock
CS33148,0002A8E -19-08JUL08-2/3
CS33148,0002A8E -19-08JUL08-3/3
35D and 50D Operation & Tests
070914
PN=425