Troubleshooting; Maintenance - CyClone BX212 Installation And Operation Instruction Manual

TROUBLESHOOTING

ISSUE CAUSE
1.
installation.
2.
are not connected properly.
3.
extension (SS130 only).
Light indicates power
1.
ON but motor doesn't
turn.
2.
1.
2. Damaged blower wheel.
3.
4. Venting duct too small or blockage in the duct
opening or ductwork.
Motor works but lights 1. Defective light bulb.
do not turn on.
2.
1.
out properly.
cook top.
2. Blockage in the duct opening or ductwork.
3. Using the wrong size of ducting.
22 Cyclone Insert Installation - English
SOLUTION
1. Ensure power is ON for the circuit breaker and
unit.
2. Check the power connection with the unit is
connected properly.
3.
0.
1. Change the motor. Servicing may be required.
2. Change defective part. Servicing may be
required.
1. Tighten the motor in place.
2. Replace the blower wheel. Servicing may be
required.
3. Check the installation of the hood.
4. Check the venting duct and the wall cap or roof
cap.
1. Change the light bulb.
2. Tighten the light bulb.
1. Adjust the distance between the cook top and
the bottom of the hood within 28" - 36" above
the range.
2. Remove all the blocking from the duct work or
duct opening.
3. Use at least 6" duct work.

MAINTENANCE

For a complete description of our maintenance and operating instructions you may visit us online at
www.CycloneRangeHoods.com to download your model's Use and Care Guide.
Due to the fact that we are always striving to improve our products and take advantage of advances in technology there may
be slight variations in your product.
WARNING
•
maintenance.
Surface and Filter Cleaning:
Clean with warm soapy water and a clean cloth. Do not use corrosive
or abrasive detergent or steel wool pads that can scratch the surface
of the machine.
grain. Scrub lightly.
thoroughly every 30 to 60 days depending on cooking habits. Filters
may be placed on the top rack of the dishwasher or soaked in warm,
soapy water.
Spray degreasing detergent and leave to soak if heavily soiled.
Replacing Lightbulbs:
WARNING
•
operation on the appliance.
• In order to prevent the risk of personal injury, the halogen
lamps must be cooled before removal.
• Use LED bulb, 1.5W maximum per bulb, for SS130.
• *Bulb & socket may change.
To change bulbs for BX212/BX215/BX600/BX360/CLX60
1.
clockwise until bulb is loosened.
To change bulbs for SS130:
To change the light bulb, remove light case from the light socket.
machine.
i. Disconnect the connecting wires of the light socket from the
motherboard wires.
ii.
the machine.
iii. Replace with a new case.
Cyclone Insert Installation - English 23