1.
Remove the four Phillips M2.0 × 2.0 screws (1) from the touchpad bracket, and then remove the
bracket from the computer (2).
2.
Lift the shielding (1) from the top of the touchpad.
3.
Disconnect the touchpad cable from the ZIF connector (2) on the touchpad.
4.
Remove the four Phillips M2.0 × 2.0 screws (3) from the touchpad.
5.
Remove the touchpad from the computer (4).
To install the touchpad, reverse this procedure.
System board
To remove the system board, use these procedures and illustrations.
System board
41