Sealey AK41.V3 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Disconnect the gun from the air supply before changing accessories, servicing or performing any maintenance.
ˆ
Maintain the gun in good condition. Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be
9
dangerous and will invalidate the warranty.
Keep children and unauthorised persons away from the work area.
9
Avoid unintentional operation.
9
Ensure caulking compound manufacturer's instructions are carefully followed.
9
DO NOT hold gun or attachments close to your face (especially eyes, ears, etc.) and do not point gun or air hose at other persons or
8
animals.
DO NOT carry by the air hose, or yank the hose or the gun from the air supply.
8
DO NOT use the gun for any purpose other than that for which it is designed.
8
DO NOT operate the gun if damaged.
8
When not in use disconnect from the air supply and store in a safe, dry, childproof area.
8
2. INTRODUCTION
Accepts standard 310ml cartridges. Fitted with trigger control for smooth application of caulking.
3. SPECIFICATION
Model no: ................................................................AK41.V3
Air Consumption.......................................................... 3.5cfm
Air Inlet Size: .............................................................1/4"BSP
Maximum Working Pressure: ............................ 3bar(43.5psi)
Overall Length: ........................................................... 300mm
Recommended Air Pressure: .............................. 36 - 43.5psi
4. PREPARATION
4.1. AIR SUPPLY
4.1.1. Recommended hook-up procedure is shown in fig.2.
4.1.2. Ensure tool valve (or trigger) is in the "off" position before connecting to the air supply.
4.1.3. You will require an air pressure stated in Section 3 and an air flow according to specification.
WARNING! Ensure the air supply is clean and does not exceed the stated value in Section 3 while operating the tool. Too high an air
ˆ
pressure and/or unclean air will shorten the product life due to excessive wear, and may be dangerous causing damage
and/or personal injury.
4.1.4. Drain the air tank daily. Water in the air line will damage the tool.
4.1.5. Clean air inlet filter weekly.
4.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8 meters). The minimum hose diameter should
be 1/4" I.D. and fittings must have the same inside dimensions.
4.1.7. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all connections are secure.
4.2. COUPLINGS
4.2.1. Vibration may cause failure if a quick change coupling is connected directly to the tool. To overcome this, connect a leader hose to
the tool.
4.2.2. A quick change coupling may then be used to
connect the leader hose to the air line
recoil hose. See fig.2.
© Jack Sealey Limited
CAULKING GUN 230MM AIR OPERATED
AK41.V3
MODEL NO:
Wear Wear ear
Gloves protection
fig.2
Original Language Version
A
B
AK41.V3 Issue: 1 04/08/22