Table of Contents
Advertisement
System Information
To view the system information on the Intimidator Spot 375ZX , do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Sys Info.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Ver (displays the firmware version), Running Mode (displays the
current running mode), DMX Address (displays the current DMX address), or Temperature
(displays the product temperature in °C).
Master/Slave Mode
The Master/Slave mode allows a single Intimidator Spot 375ZX product (the "master") to control the
actions of one or more Intimidator Spot 375ZX products (the "slaves") without the need of a DMX
controller. The master product will be set to operate in either the standalone mode or with the RF remote,
while the slave products will be set to operate in slave mode. Once set and connected, the slave products
will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from Slave1, Slave2, Slave3, or Slave4.
•
Select Slave1 for 100% synchronized actions.
•
Select Slave2, Slave3, and/or Slave4 for delayed actions, creating a wave effect.
7. Press <ENTER>.
8. Connect the DMX input of the first slave product to the DMX output of the master product.
9. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
10. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode.
2. Make the master product the first product in the DMX daisy chain.
•
Configure all the slave products before connecting the master to the daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
•
Do not connect more than 31 slaves to the master.
RFC Remote Control
The Intimidator Spot 375ZX can be operated with an RFC remote or an RFC-XL remote (sold separately).
To enable RF control, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select RF.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select among RFP (enables the fixture to respond to all RF signals) or
RF(1-4) (sets which group of fixture the RFC/RFC-XL remote will control).
7. Press <MENU>.
8. Use <UP> or <DOWN> to select RF.
9. Press <BIND>
10. Long press <BLACKOUT> on the remote.
For more information about using an RFC or RFC-XL remote, download the Instructions
and User Manual from www.chauvetdj.com.
18
Intimidator Spot 375ZX User Manual Rev. 1
Operation
Advertisement
Table of Contents
