Self-Test - BIXOLON SRP-QE300 User Manual

Thermal receipt printer

Hide thumbs Also See for SRP-QE300:

Table of Contents

5. Self-Test

The self-test checks whether the printer has any problems.

If the self-diagnostics reveal no error in the printer, please see other device or software.

If the printer does not run normally, please contact the place of purchase.

- Do not open the top cover while the printer is running.

It may damage the printer.

- If the printer does not run normally, please contact Customer

Center.

1) Make sure paper roll has been installed properly.

2) Turn on the power while holding down the FEED button and the self-test begins.

3) The self-test prints the current status of the printer including control ROM version.

4) After printing the current printer status, the printer wait for the next step after

printing the following lines. (The paper signal light keeps blinking.)

Memory switch configuration mode : Press and hold down button

5) Press the Feed button to resume printing or hold down the button for at least one

second to change the VMSM settings.

Ver. 2.00

Select a button to run the following.

Continue test printing

SELF-TEST PRINTING.

: Press the button briefly

- 24 -

SRP-QE300/QE302

Table of Contents