SMALCO HAE84715 Manual page 2

10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
Connect to properly grounded outlets only.
This heater is for use on 120 volts. This appliance has a grounded plug as shown
in Fig. 1. An adapter, as shown, is available at retail (not included) for connecting
three-blade grounding-type plugs to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to a permanent ground such as a
properly grounded outlet box. The adapter should not be used if a three-slot
grounded receptacle is available. Do not circumvent the safety features of the
grounding-type plug. Do not modify the power cord.
Fig. 1
METAL SCREW
. COVER OF ))
(1) | otnereox~| ©)
GROUNDING PIN
IMPORTANT SAFETY yF
INSTRUCTIONS REGARDING GROUNDING ADAPTOR Ù GROUNDING LUG
THE PLUG ON YOUR PRODUCT.
This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.
It is normal for the plug to feel warm to the touch; however, a loose fit between the
AC outlet (receptacle) and plug may cause overheating and distortion of the plug.
Contact a qualified electrician to replace loose or worn outlet.
To disconnect the heater, first turn controls to the OFF position, then grips the plug
body and pull it from the wall outlet. Never pull by the cord.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or damage to the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do
not use on soft surfaces, like abed, or where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint or flammable liquid are used or stored.
Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
Always plug heater direct into a wall outlet /receptacle. Avoid the use of an
extension cord because the extension cord may overheat and cause a risk of fire.
ENG 2
20. Never tamper with this product or attempt to fix it. Any tampering with, or
modification of, this product can result in serious injury, death, fire or risk of electric
shock. Do not open, no user serviceable parts inside.
21. Do not remove product labels that contain warnings or safety instruction.
22. The output of this heater may vary and its temperature may become intense enough
to burn exposed skin. Use of this heater is not recommended for persons with
reduced sensitivity to heat or an inability to react to avoid burns.
23. Before cleaning, or storage, or when not in use, turn the product's controls to the
OFF position and unplug the heater from the electrical outlet and allow it to cool.
24. If your home has aluminium wiring, have a licensed electrician check your
receptacle's connections. When using a 1500 watt heater, aluminium wire
connections can cause a safety issue.
25. Place the heater on a firm, level, open surface free from obstructions and at least
3 feet (0.9 m) away from any combustible materials. DO NOT use on an unstable
surface such as bedding or deep carpeting. Be sure the heater is not in a position
where it may be tipped over by small children or pets. The heater's rubber wheels
will hold it firmly in position.
SAVE THESE INSTRUCTIONS
ELECTRICAL RATINGS
This product is rated 12.5 Amps (1500 Watts) at 120 VAC, 60 Hz.
SET-UP WHEEL BASE ASSEMBLY
NOTE: DO NOT OPERATE THE HEATER WITHOUT THE WHEEL BASE ASSEMBLIES
IN PLACE .THE HEATER MUST ALWAYS BE USED IN AN UPRIGHT POSITION. DO
NOT OPERATE THE HEATER IF THE WHEELS ARE NOT ASSEMBLED CORRECTLY.
» Make sure the heater is unplugged and in the OFF position.
» Turn the heater upside down to install wheels.
ENG 3