Advertisement
7.2.6.
Install the rear panel (21), reflective panel (23) and the side panel (19).
7.2.7.
Use a piece of soft cloth to clean the reflective panel and tube with alcohol, remembering to let it evaporate before use.
7.2.8.
Install the front protective grill (14).
fig.5
8. TROUBLESHOOTING
DEFECT
Small pores on the baked paint surface
Dim paint
Stains
Fuzzy edge
Uneven baking
NOTE:
For optimal baking performance, we recommend that users should work out the suitable operating procedures, baking time and
distance according to the local conditions, working environment and the type of paint.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
CAUSE
Lamp too close to the repaired surface.
Insufficient preheating time.
Fast thinning agent included in the paint.
Lamp too far away from the repaired surface.
Insufficient Baking.
Too thick coating.
Too long baking.
Too close.
The repair surface is too large.
The lamp is not at the correct height.
sales@sealey.co.uk
Original Language Version
TROUBLESHOOTING
Increase the distance.
Increase the preheating time.
Use standard or slow thinning agent.
Move dryer closer.
Increase the baking time
Thin the coating.
Shorten the baking.
Increase the distance.
Separate it into two pieces for baking.
Adjust the lamp to allow it to be as height as the
repaired surface.
www.sealey.co.uk
IR3000S Issue:3 31/05/23
REGISTER YOUR
PURCHASE HERE
Advertisement
