Sealey WORKSAFE SSP1.V6 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT
IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. INTRODUCTION
Direct ventilation allows for maximum airflow to prevent fog. Elasticated strap holds the goggles securely in place. Soft rim provides
optimum comfort for long periods of use. BS EN 166 Impact and scratch resistant durable polycarbonate lens provides protection
against projectiles.
Notified Body: 2777
Type Examination Certificate Number: 2777/13872-01/E00-00
Carried Out By: SATRA
2. SAFETY
Always perform a risk assessment and follow correct health and safety procedures before using this product.
9
WARNING! Safety glasses with polycarbonate lenses are impact resistant but may break under severe impact.
‰
WARNING! Materials which may come into contact with the wearer's skin could cause allergic reactions to susceptible individuals.
‰
WARNING! Scratched or damaged oculars should be replaced.
‰
WARNING! Eye protectors against high speed particles worn over standard ophthalmic spectacles may transmit impacts, thus creating
‰
a hazard to the wearer.
DO NOT use tinted or clear lenses when welding or performing other operations which expose your eyes to harmful levels of radiation.
8
DO NOT use for grinding or welding.
8
IMPORTANT: if protection against high speed particles at extremes of temperature is required, then the selected eye-protector should
be marked with the letter 'T' immediately after the impact letter, i.e. FT, BT or AT. If the impact letter is not followed by the letter 'T' then
the eye protector shall only be used against high speed particles at room temperature. If the symbols F, B and A are not common to
both the ocular and the frame then it is the lower level which shall be assigned to the complete eye-protector.
3. APPLICATIONS
3.1. EN 166 CATEGORISATION
• Optical Class 1 - suitable for work with high vision requirements for permanent use.
3.2. FIELD OF USE
• B - High speed particle, medium energy impact
• 3 - Protection against droplets of liquids
4. MAINTENANCE
4.1. CLEANING
DO NOT use abrasive materials.
8
Using a soft and clean brush or cloth, use warm suds to wash and clean. Ensure hands are clean (without grease).
9
Materials which may come into contact with the wearer's skin could cause allergic reactions to susceptible individuals. The contact
9
areas should be disinfected regularly.
4.2. STORAGE
Store in a bag or case out of direct sunlight, away from chemicals and abrasive substances, in a clean dust free environment.
9
Use original bag for transportation if possible.
9
4.3. OBSOLESCENCE
Like all protective products, the life depends on the type of use, care and maintenance. If damaged, replace the entire article. In every
case, the product must be replaced after a period of two years.
© Jack Sealey Limited
SAFETY GOGGLES - DIRECT VENT
SSP1.V6
MODEL NO:
Original Language Version SSP1.V6 Issue 1 23/11/23