Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ViewSonic LiteBird PJ853
Summary of Contents for ViewSonic LiteBird PJ853
- Page 1 L I T E BIRD User Guide Guide de l’utilisateur Bedienungsanleitung (International Spanish) (Italian) (Brazilian Portuguese) (Swedish) (Russian) (Polish) (Japanese) (Traditional Chinese) (Simplified Chinese) (Korean) Image Size 30” – 300” (Arabic) Super Bright SVGA LCD Projector...
-
Page 2: Table Of Contents
Power Indicator Lights ...14 Screen Messages ...14 Maintenance ...15 Lamp Replacement Installing Battery (for remote control) ...16 Cleaning Instructions ...16 Air-Filter ...17 Customer Support...18 LIMITED WARRANTY VIEWSONIC Projector ...19 Appendix Power Cord Safety Guidelines...20 FCC Information ...21 ...15 ViewSonic PJ853... -
Page 3: For Your Records
NERGY ® Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use this product. -
Page 4: Getting Started
• Do not service the unit yourself; doing so could cause injury. • Do not operate the projector near water or in a humid area. Do not sit drinks on or near the projector; doing so could cause a burn or short an electrical circuit. -
Page 5: Connect Input And Output Devices
Power Switch (to the power cord) Connect Input and Output Devices The figure below shows the ports and configurations for connecting external devices to the ViewSonic PJ853. See “Installation Steps” on page 4. Reset Mute Input Standby/ON Speaker S-video IN port... -
Page 6: Installation Steps
LED blinking for 1 minute. The power switch on the side of the projector may be turned off after 1 minute, when the power light is a steady orange. -
Page 7: Adjusting The Projector Angle
Adjust the projection angle using the foot adjusters shown in the illustration. See also KEYSTONE under "Input Menu on page" 9. Press the release button to lower the front foot, then tilt the projector up as shown in Figure 5 below. -
Page 8: Using The Projector
This is a safety feature. Input Button (Video and RGB Buttons) The INPUT button shown is on the projector only. Use the Video and RGB buttons on the remote control to select the input source. -
Page 9: Menu Button
Use the OFF button to turn off magnification. Reset Button The RESET button shown with the arrow and dot icon is on the projector only. The RESET button on the remote control has no marking but is labeled RESET. Press the Reset button to restore the factory default settings. -
Page 10: Onview Indicators
To access and adjust the OnView screens do the following: Press the MENU button on the projector control pad or remote control to access on-screen options and display the SETUP Main Menu. -
Page 11: Input Menu
The Image menu displays 4 options that are explained below: Keystone corrects image distortion that may occur when the angle of the projection is increased. Keystone resizes the top or bottom of the projected image. See “Adjusting the Projector Angle” on page 5. -
Page 12: Options Menu
Select V: Invert for a front projection ceiling mount. Select H&V: Invert for a rear projection ceiling mount. Start up selects a start-up menu. You may select or deselect the ViewSonic Welcome menu to display automatically at start-up. Options Menu... -
Page 13: Other Information
Power Operating conditions Storage conditions Dimensions and weight Regulations May require a Macintosh adapter ViewSonic PJ853 Type Three 0.7” 800 x 600 polysilicon, active matrix TFT LCD Pixels 1,440,000 (800 dots x 600 lines x 3 colors) Colors 16.7 million Type Manual zoom (1.2x), manual focus... -
Page 14: Timing Chart
Mac 13” mode VGA-3 (72Hz) VGA-3 (75 Hz) VGA-3 (85 Hz) SVGA (56 Hz) SVGA (60 Hz) SVGA (72 Hz) SVGA (75 Hz) SVGA (85 Hz) Mac 16” mode XGA (60 Hz) XGA (70 Hz) XGA (75 Hz) ViewSonic PJ853... -
Page 15: Troubleshooting
Have the projector repaired by an authorized dealer. The lamp shuts off • A minor power surge may cause the lamp to shut off. Press the Power button twice to turn off the projector. Let the projector cool down, then restart. •... -
Page 16: Power Indicator Lights
Power Indicator Lights If the Lamp or Temperature indicator is red or flashing red when the ViewSonic PJ853 is powered- on, there is a problem and you should not proceed. Power-off the the projector and let it cool down. Power Indicator... -
Page 17: Maintenance
ViewSonic PJ853 Lamp Unit • To order a new lamp unit (part number RLC-130-03A) contact ViewSonic Customer Support: “Customer Support” on page 18. Lamp Bulb • Estimated lamp life is 2000 hours. WARNING: Make sure the power cord is disconnected. -
Page 18: Installing Battery (For Remote Control)
• The battery is not rechargeable. Pull the plastic tab from the battery access door when using the new projector for the first time. Pinch the battery holder at the bottom of the remote control and gently pull out the holder with the battery. -
Page 19: Air-Filter
You may also hand-wash the filter in warm water. (See warning below.) Replace the air-filter. Replace the filter cover. Do not power-on the projector unless you are sure the filter is completely dry. Humidity WARNING: or steam can damage the projector. -
Page 20: Customer Support
New Zealand T: 64-3-366-1135 F: 64-3-366-7006 Singapore/Southeast Asia T: 65-273-4018 F: 65-273-1566 Other Asia/Pacific countries T: 886-2-2248-4072 and Indian Peninsula F: 886-2-2240-8238 South Africa T: 27-11-314-0002 F: 27-11-314-0002 Email vstech@viewsonic.com vstech@viewsonic.com ---------------------------- ----------------------------- ----------------------------- mbarlass@vistech.co.nz viewsonicspore@pacific.net.sg vsi@viewsonic.com.tw atscom@mweb.co.za ViewSonic PJ853... -
Page 21: Limited Warranty
How long the warranty is effective: ViewSonic projectors are warranted for three (3) years for all parts excluding the lamp, three (3) years for all labor, and ninety (90) days for the lamp from the date of the first consumer purchase. -
Page 22: Appendix
If you have any questions concerning which proper power cord to use, please consult with the dealer from whom you have purchased the product. Switzerland ...SEV Britain...BASE/BS Japan ...Electric Appliance Control Act Figure A1 Maximum Current Rating of Unit 10 Amps 12 Amps 12 Amps 10 Amps 12 Amps ViewSonic PJ853... -
Page 23: Fcc Information
CE Conformity The device complies with the requirements of the EEC directive 89/336/EEC as amended by 92/ 31/EEC and 93/68/EEC Art.5 with regard to “Electromagnetic compatibility,” and 73/23/EEC as amended by 93/68/EEC Art.13 with regard to “Safety.” ViewSonic PJ853... - Page 24 ViewSonic Corporation 381 Brea Canyon Road Walnut, CA 91789 Tel (909) 869-7976 Tel (800) 688-6688 07/2000 Fax (909) 468-1202...
Need help?
Do you have a question about the LiteBird PJ853 and is the answer not in the manual?
Questions and answers