Panasonic SA-AK66 Service Manual page 13

- Installation of the CD servo P.C.B. after replacement Step 2 Remove the wires at CN302, CN303 and CN304 and
pull out the Main P.C.B.
Step 1 Connect the FFC board.
Step 3 Remove 4 screws fixed to the Power Amplifier IC.
Step 2 Install the CD servo P.C.B. in the traverse deck
assembly. Power Anip IC
C501
Reset detect |
switch 4
iyi OLE PES
ile, = Be
Solder Step 4 Unsolder the terminals of Power Amp IC and replace
the respective component.
Note:
Before installing the CD servo P.C.B., move the optical pickup
towards the outer edge from the marking (black triangle).
[Otherwise, the reset detect switch (S701) mounted on the CD
servo P.C.B. may be damaged.]
Optical Marking "<q"
pickup
* Rotate the gear to move
the side A of optical pickup
toward the outer edge from
the marking "<q".
2. Replacement of the Power Amplifier IC
Step 1 Follow the procedures in 'Checking Procedure for each Power PCB
major P.C.B.' ( Step 1 - Step 4 ).
rower
r.\.B,
Heat sink
Step 3
€ x2
Power P.C.B.
13