Related Manuals for Amish Country Gazebos Vinyl
Summary of Contents for Amish Country Gazebos Vinyl
- Page 1 Gazebos www.AmishGazebos.com 1-(800)700-1777 Vinyl Gazebo-in-a-Box Assembly Instructions 2023...
-
Page 2: Getting Started
Getting Started Thank you for ordering an Amish Country Gazebos In-A-Box structure! Our hope with your new structure is that you are able to Relax, Connect, and Entertain! Please read the entire assembly manual before starting assembly. If you have questions regarding the installation of your gazebo kit, please call our... -
Page 3: Site Preparation
Site Preparation It is most important to have a solid, flat and level foundation for your gazebo. Indicate the location of your gazebo foundation by doing the following: FLOOR DIMENSIONS TABLE 1.Cut 8 boards at a 22.5˚ angle. Each should be the length of dimension ‘C’... - Page 4 Gazebo Deck (Optional) If you ordered a floor with your gazebo, you will have received (8) triangular shaped floor panels. Note: Each floor panel has (2) boards that are temporarily fastened with small nails. 3. Remove and 1. Place each of the (8) triangular 2.
- Page 5 Handrail end cap Handrail baluster Handrail crimped baluster Handrail plate 1. Organize each handrail component as 2. Fasten one end of each end cap to one of the handrail shown in this photo. plates with (2) 2 1/2" white screws in each end. Then insert all of the balusters into the pin routed holes of this plate.
-
Page 6: Roof Installation
Gazebo Wall Sections Note: Make certain that the high point of each post is facing in toward the center of your gazebo. 1. Attach each of the post bases to 3. Begin by installing the upper rail by the 2. Center and attach the bottom of each post using 2 ½”... - Page 7 5. Now install the 6. Next, using a step ladder, reach to 7. Lastly, drive (1) 2½” white the roof peak and drive (1) 2½” white remaining (4) rafters. screw through each upper rail screw through the remaining rafter end cap and into the post. Do top into the ceiling center block.
- Page 8 3. Next, go to the center of the plywood panel where it meets the fascia board. Push or pull the fascia board slightly to properly align it, then drive (1) 2” screw through the plywood and into the fascia board. Note: Only (1) screw is required per section to connect the plywood to the fascia board.
- Page 9 Shingles Note: If you ordered additional accessories, such as electrical, screens and/or benches, please refer to those instructions prior to installing the shingles. Both screens and benches need to be installed prior to electrical installation, and electrical prior to shingle installation. Identifying your shingles Starter Shingle Architectural Shingle...
- Page 10 Ridge Caps Make your ridge cap shingles by cutting a 3 tab shingle into (3) individual pieces. 1. Turn the shingle over to expose the reverse side. Then 2. Place the first ridge cap shingle at the use a utility knife to cut each ridge cap piece. Begin your bottom edge of your roof ridge so that cut at the manufactured cutout and cut at a slight angle the black tar area of the shingle is very...
- Page 11 3. To create ridge cap shingles for 4. Use roofing nails to apply (1) of these strips over each your cupola, cut (3) 1½” wide strips ridge seam of your cupola roof. out of (1) ridge cap shingle. Note: If you have a staple gun, you can use it for the cupola shingles.
Need help?
Do you have a question about the Vinyl and is the answer not in the manual?
Questions and answers