Nero Backitup 2 Software; Connecting To Your Computer - Verbatim 96759 User Manual

Nero BACKITUP 2 Software

Nero BACKITUP 2 back up software is included on the hard drive. Double click the Nero
folder on the drive and then double click the setupx file to start installation. The Nero
Installation window will appear. Follow the set up wizard to install the software.

Connecting To Your Computer

This Verbatim external hard drive provides both USB 2.0 and eSATA connections. You can
connect your drive to a computer with either USB or eSATA, but not both at the same time.
Connecting your drive to a computer is extremely simple. Follow the steps below.
1. Connect the included AC Adapter to the drive, and then to a wall outlet.
2. Next press the ON/OFF button on the back of the drive.
3. Finally, connect the data cable. Connect the included USB cable from the USB port on
the drive to an available USB port on your computer. For eSATA, connect the included
eSATA cable from the eSATA port on the drive to an available eSATA port
on your computer.
4. The hard drive will mount automatically, and a new icon will appear in My Computer
(Windows) or a new icon will appear on the desktop (Mac).
Depending on your computer's operating system and the interface type you are using, the
following special notes may apply:
Note 1: USB under Windows. If you are using a USB 1.1 port on your Windows computer,
the following cautionary note may appear on your display: Hi-Speed USB Device plugged
into non-Hi-Speed USB hub. This does not indicate a problem because the drive is compat-
ible with both USB 1.1 and USB 2.0 ports. Simply close the message and proceed. However,
4