Rear Panel Controls - Kenwood TS-600 Operating Manual

FCC Data: Receiver Model No.
TS-600. Receiver is certified to
meet FCC Part 15 as of date of
manufacture.
@ fate)
= | 0000000000 «=
&d "© SP
3-2. REAR PANEL CONTROLS
@ ANT TERMINAL
For connection of antenna.
@ NAME PLATE
TS-600 serial number is marked on this plate.
@) HEAT SINK (FOR TRANSMITTER FINAL STAGE)
For protection of transistors from overheating.
@ RL-MAKE TERMINAL (RELAY TERMINAL)
This terminal should be OFF during reception, and should
be grounded during transmission.
@® KEY JACK
This jack is used for operating the transceiver in CW mode.
Connect an external telegraphic key device.
© ALC-INPUT TERMINAL
External ALC terminal.
@ EXT SP TERMINAL
For connection of an external speaker.
120V /2A acizoy/230V a aoe
220V /1A
POWER CORD JACK
For connection
of the supplied AC power cord (or DC
power cord).
@ AC FUSE HOLDER
For AC power fuse (primary). (120V-+2A or 220V->1A)
@ VOX SOCKET
For connection of a voice control unit. When VOX unit is
not connected, be sure to insert the 9-pin MT plug into
the socket.
@), AC POWER SELECT SWITCH
Set this switch to your local AC voltage, 120V or 220V.